Husqvarna 968999239, SG13A / CE manual Preparations

Page 9

SAFETY INSTRUCTIONS

Preparations

Make sure that you always have first aid equipment at hand when using the machine.

Make sure nobody else is in the vicinity of the machine when you start the engine, engage the drive or run the machine.

Make sure animals and people maintain a safe distance from the machine.

Clear the area of objects such as stones, toys, steel wire, etc. that could become caught in moving machine parts and thrown out.

Find and locate all fixed objects in the ground, such as sprinkler systems, poles, water valves, bases for washing lines, etc. Be certain to check for hidden electrical cables or similar in the surface of the lawn. Always run the machine around these objects. Never intentionally run the machine over foreign objects.

Check that the dead man’s grip and all guards are fitted and functioning. DO NOT use the machine if it is not working properly.

Makes sure no clothing, long hair or jewelry can catch in moving machine parts.

Check that all safety decals are in place. See the chapter “Location of decals”.

Use mouth protection, protective gloves with good grip and protective clothing which you can move unrestricted. Also use leg protection to protect your legs from sparks and the cutting tools.

Never use the machine when barefoot. Always wear protective shoes or protective boots with anti-slip and preferably with steel toes.

Use a helmet with a full face visor or a mesh visor and protective glasses. Wear approved ear-protection when running the machine. Ask your dealer about approved protective glasses, ear protection and recommended helmets.

8011-198

Clear the work area before beginning work.

8011-189

Use appropriate equipment.

WARNING!

Always use approved protective clothing and approved protective equipment when using the machine. Protective clothing and protective equipment cannot eliminate the risk of accidents, but wearing proper clothing and the correct equipment will reduce the degree of injury should an accident occur. Ask your dealer about approved protective clothing and approved protective equipment recommended by Husqvarna.

9

Image 9
Contents Manual no REV 03/08/04 Operator’s Manual Model 968999239Husqvarna All Rights Reserved Printed Beatrice, Nebraska Table of Contents Introduction Decals and machine-bound instructions Symbols and DecalsLocation of decals Translation of instructions Decal Important informationDecal General use Safety InstructionsSafety Instructions Preparations Operating Movement/Transport StorageChildren Fuel system Maintenance Personal equipment Protective EquipmentEquipment set-up SET-UPHair PIN Engine Controls PresentationMain components and operating controls Engine Throttle12 11 Starter handle StarterFuel valve Choke controlMuffler Spark plugOil dipstick Oil drainageFueling Fuel tankCentrifugal clutch Dead man’s grip barAdjustment bar for the handle On/Off Engine switch on the panelBrake Never operate a machine with a defective brakeStarting the engine OperationEngine switch on the handle Dead man’s grip barStarter handle Normal shutdown Engine switchShutdown in emergency situations BrakeBefore you start Using your stump grinder 8011-202chg Shut off the machine when you are done Operating on hillsTransport Maintenance schedule MaintenanceCleaning the cyclone filter Replacing the air filter Idle adjustment Cleaning the sludge reservoirFitting the wrong spark plug type can damage the engine Ignition systemAdjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Adjusting the brake Cleaning and washingTwo minute rule Blade shaft bearings LubricationChecking the engine’s oil level Engine oilThrottle cable Right wheelSymptom Cause Action TroubleshootingProblem Possible solutions Service StorageWinter storage Model Technical DataWiring Diagram Delivery service Service JournalService Journal