Husqvarna SG13A / CE, 968999239 manual Cleaning the cyclone filter

Page 32

MAINTENANCE

Cleaning the cyclone filter

The cyclone filter collects the largest contaminant particles, which collect in the container. When you can see a layer of dirt at the bottom of the container, the cyclone housing (4), air channels and air intake screen (3) must be cleaned.

Remove the three screw holding the cyclone housing. Remove the housing with the air intake screen and remove the air channels.

The air channels may remain in the upper portion or follow along with the housing when removed.

8011-188

8011-213

Clean the components. Use water, detergent and a washing-up brush. Dry carefully.

IMPORTANT INFORMATION

Exercise care when reassembling to avoid damaging anything.

Make sure when mounting that the air intake screen fits exactly in its guide in the upper portion.

Make sure the air channel ends up in the proper position.

Refit the components. Place the air channels in the cyclone housing. Insert cyclone housing into position and make sure it fits in the upper portion. DO NOT use force; rather coax it into place before fitting the screws.

8011-212

8011-213

32

Image 32

Contents Operator’s Manual Model 968999239 Manual no REV 03/08/04Husqvarna All Rights Reserved Printed Beatrice, Nebraska Table of Contents Introduction Symbols and Decals Decals and machine-bound instructionsDecal Location of decals Translation of instructionsDecal Important information Safety Instructions General useSafety Instructions Preparations Operating Children Movement/TransportStorage Fuel system Maintenance Protective Equipment Personal equipmentSET-UP Equipment set-upHair PIN Engine Main components and operating controls ControlsPresentation 12 11 EngineThrottle Starter Starter handleFuel valve Choke controlSpark plug MufflerOil dipstick Oil drainageFuel tank FuelingCentrifugal clutch Dead man’s grip barOn/Off Engine switch on the panel Adjustment bar for the handleBrake Never operate a machine with a defective brakeOperation Starting the engineStarter handle Engine switch on the handleDead man’s grip bar Engine switch Normal shutdownShutdown in emergency situations BrakeBefore you start Using your stump grinder 8011-202chg Transport Shut off the machine when you are doneOperating on hills Maintenance Maintenance scheduleCleaning the cyclone filter Replacing the air filter Cleaning the sludge reservoir Idle adjustmentIgnition system Fitting the wrong spark plug type can damage the engineAdjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Two minute rule Adjusting the brakeCleaning and washing Lubrication Blade shaft bearingsEngine oil Checking the engine’s oil levelRight wheel Throttle cableTroubleshooting Symptom Cause ActionProblem Possible solutions Winter storage ServiceStorage Technical Data ModelWiring Diagram Service Journal Delivery serviceService Journal