Husqvarna 968999239, SG13A / CE manual Engine, Throttle, 12 11

Page 19

CONTROLS

Engine

Exterior engine components and controls.

1.Throttle

2.Starter

3.Starter handle

4.Fuel valve

5.Choke control

6.Air filter

7.Spark plug

8.Muffler

9.Oil dipstick

10.Oil drainage

11.Oil level guard

12.Engine switch - disconnected use switch on handle bar

13.Fuel tank

14.Fuel filler cap

Throttle

The lever on the engine is normally not used. It is connected to the throttle on the handle. If the cable should bind or break, you can reduce the throttle with the lever on the engine as an emergency measure to slow the engine speed to an idle and stop the cutting wheel.

10

8011-126

14

13

12 11 9

8011-273chg

THROTTLE

LEVER

8011-034

19

Image 19

Contents Manual no REV 03/08/04 Operator’s Manual Model 968999239Husqvarna All Rights Reserved Printed Beatrice, Nebraska Table of Contents Introduction Decals and machine-bound instructions Symbols and DecalsDecal Important information Location of decals Translation of instructionsDecal General use Safety InstructionsSafety Instructions Preparations Operating Storage Movement/TransportChildren Fuel system Maintenance Personal equipment Protective EquipmentEquipment set-up SET-UPHair PIN Engine Presentation ControlsMain components and operating controls Throttle Engine12 11 Choke control StarterStarter handle Fuel valveOil drainage Spark plugMuffler Oil dipstickDead man’s grip bar Fuel tankFueling Centrifugal clutchNever operate a machine with a defective brake On/Off Engine switch on the panelAdjustment bar for the handle BrakeStarting the engine OperationDead man’s grip bar Engine switch on the handleStarter handle Brake Engine switchNormal shutdown Shutdown in emergency situationsBefore you start Using your stump grinder 8011-202chg Operating on hills Shut off the machine when you are doneTransport Maintenance schedule MaintenanceCleaning the cyclone filter Replacing the air filter Idle adjustment Cleaning the sludge reservoirFitting the wrong spark plug type can damage the engine Ignition systemAdjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Cleaning and washing Adjusting the brakeTwo minute rule Blade shaft bearings LubricationChecking the engine’s oil level Engine oilThrottle cable Right wheelSymptom Cause Action TroubleshootingProblem Possible solutions Storage ServiceWinter storage Model Technical DataWiring Diagram Delivery service Service JournalService Journal