Husqvarna SG13A / CE Location of decals Translation of instructions, Decal Important information

Page 6

SYMBOLS AND DECALS

Location of decals

5 9 3 12

8

10

4

11

7

2

6

1

Translation of instructions

Decal 3

Important information

Read and make sure you understand the Operator’s Manual before use or maintenance.

To obtain a replacement manual, please contact your dealer.

Observe all safety instructions; otherwise you may injure yourself or others around you.

Make sure that the machine is in serviceable con- dition prior to use.

Stop the engine and wait until all machine move- ment comes to a standstill before service, adjust- ment or cleaning.

Do not run the engine in poorly ventilated spaces.

Make sure nobody is in the vicinity of the machine before starting and during use.

Avoid slopes that are too steep to use the ma- chine safely.

Clear any debris prior to use.

Decal 4

Warning

Engine exhaust, some of its constituents and cer- tain vehicle components contain or emit chemicals considered by the Sate of California to cause can- cer, birth defects or other reproductive harm. The engine emits carbon monoxide, which is a color- less, poisonous gas. DO NOT use the machine in enclosed spaces.

Decal 5

Wear goggles or safety glasses and ear protec- tions when using the unit.

Decal 6

There is DANGER to your feet from the cutting blades.

Decal 8

O = off, I = on

Decal 9

Rabbit = Fast engage clutch.

Turtle = Slow disengage clutch.

Decal 10

Handle adjustment.

Decal 11

No step.

Decal 12

Sound power rating.

6

Image 6
Contents Operator’s Manual Model 968999239 Manual no REV 03/08/04Husqvarna All Rights Reserved Printed Beatrice, Nebraska Table of Contents Introduction Symbols and Decals Decals and machine-bound instructionsLocation of decals Translation of instructions Decal Important informationDecal Safety Instructions General useSafety Instructions Preparations Operating Movement/Transport StorageChildren Fuel system Maintenance Protective Equipment Personal equipmentSET-UP Equipment set-upHair PIN Engine Controls PresentationMain components and operating controls Engine Throttle12 11 Fuel valve StarterStarter handle Choke controlOil dipstick Spark plugMuffler Oil drainageCentrifugal clutch Fuel tankFueling Dead man’s grip barBrake On/Off Engine switch on the panelAdjustment bar for the handle Never operate a machine with a defective brakeOperation Starting the engineEngine switch on the handle Dead man’s grip barStarter handle Shutdown in emergency situations Engine switchNormal shutdown BrakeBefore you start Using your stump grinder 8011-202chg Shut off the machine when you are done Operating on hillsTransport Maintenance Maintenance scheduleCleaning the cyclone filter Replacing the air filter Cleaning the sludge reservoir Idle adjustmentIgnition system Fitting the wrong spark plug type can damage the engineAdjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Adjusting the brake Cleaning and washingTwo minute rule Lubrication Blade shaft bearingsEngine oil Checking the engine’s oil levelRight wheel Throttle cableTroubleshooting Symptom Cause ActionProblem Possible solutions Service StorageWinter storage Technical Data ModelWiring Diagram Service Journal Delivery serviceService Journal