Ryobi Outdoor CS30, SS30, BC30 Starting and Stopping, See Figures 21, To Start a Cold Engine

Page 18

OPERATION

STARTING AND STOPPING

See Figures 21 - 23.

TO START A COLD ENGINE:

DO NOT squeeze the throttle trigger until the engine starts and runs.

nLay the trimmer on a flat, bare surface.

nPRIME - Press the primer bulb 7 times.

nSET the start lever to the START position.

nPULL the rope until the engine starts.

nAllow the engine to run for 15 seconds.

nSqueeze trigger lock and throttle trigger.

NOTE: Squeezing the throttle trigger releases the start lever to the RUN position.

TO START A WARM ENGINE: PULL the rope until the engine starts.

TO STOP THE ENGINE:

Press and hold the switch in the stop “ ” position until the engine stops.

IGNITION

SWITCH

TRIGGER

LOCK

THROTTLE

TRIGGER

Fig. 21

IGNITION

SWITCH

PRIMER BULB

TRIGGER

LOCK

THROTTLE TRIGGER

Fig. 22

START LEVER

START

POSITION

START LEVER

RUN

POSITION

Fig. 23

Page 18

Image 18

Contents Operators Manual Table of Contents IntroductionGeneral Safety Rules Read ALL InstructionsSpecific Safety Rules Specific Safety Rules for Trimmer USESpecific Safety Rules for BRUSHCUT- TER and Blade USE Symbols Symbol Name ExplanationService Symbol Signal MeaningSpecifications UnpackingFeatures CS30 RY30020, RY30023SS30 RY30040, RY30043 Removing the Attachment from the Power Head AssemblyAttaching the Power Head to the Attachment Attaching the Storage HangerAttaching the Front Handle CS30 and SS30 Attaching the J Barrier Handle BC30To Attach the Curved Shaft Grass Deflector CS30 Attaching the Grass DeflectorAttaching the Brushcutter Guard BC30 To Attach the Straight Shaft Grass Deflector SS30Removing the TRI-ARC Blade Brushcutter Guard Attaching the Shoulder Harness BC30Converting from Brushcutter to String Trimmer BC30 See Figures 10Installing the TRI-ARC Blade Brushcutter Guard Converting from String Trimmer to Brushcutter BC30Removing the Straight Shaft Grass Deflector and String Head Operation Fueling and Refueling the TrimmerOperating the Trimmer Cutting Tips To Advance the Cutting LineTo Advance the Cutting Line Manually See Figures 16TRI-ARC Blade Operating the BrushcutterBlade Thrust Cutting Technique BladeTo Start a Cold Engine Starting and StoppingSee Figures 21 To Stop the EngineNEW Prewound Spool MaintenanceSpool Replacement See Figures 24String Replacement See Figures 26Cleaning the Exhaust Port and Muffler Spark Arrestor Replacing and Cleaning AIR FilterSee Figures 29 Fuel CAP Spark PlugStorage 1 Month or Longer Troubleshooting Problem Possible Cause SolutionCall Warranty Manufacturers Warranty CoveragePage Emissions Maintenance Schedule and Warranted Parts List Service