Ryobi Outdoor CS30, SS30, BC30 Assembly, Attaching the Power Head to the Attachment, See Figure

Page 10

ASSEMBLY

ATTACHING THE POWER HEAD TO THE ATTACHMENT

See Figure 2.

GUIDE

STRING TRIMMER

SHAFT

COUPLER

WARNING:

Never attach or adjust any attachment while power head is running. Failure to stop the engine can cause serious personal injury.

The attachment connects to the power head by means of a coupler device.

1.Loosen the knob on the coupler of the power head shaft and remove the end cap from the attachment.

2.Push in the button located on the attachment shaft. Align the button with the guide recess on the power head coupler and slide the two shafts together. Rotate the attachment shaft until the button locks into the positioning hole.

NOTE: If the button does not release completely in the positioning hole, the shafts are not locked into place. Slightly rotate from side to side until the button is locked into place.

3. Tighten the knob securely.

WARNING:

Be certain the knob is fully tightened before operating equipment; check it periodically for tightness during use to avoid serious personal injury.

REMOVING THE ATTACHMENT FROM THE POWER HEAD

For removing or changing the attachment:

1.Loosen the knob.

2.Push in the button and twist the shafts to remove and separate ends.

ATTACHING THE STORAGE HANGER

See Figure 3.

There are two ways to hang your attachment for storage.

nTo use the hanger cap, push in the button and place the hanger cap over end of the lower end attachment shaft. Slightly rotate the cap from side to side until the button locks into place.

nThe secondary hole in the attachment shaft can be used for hanging purposes as well.

RECESS

BUTTON

POSITIONING

 

HOLE

KNOB

 

TRIMMER ATTACHMENT

Fig. 2

HANGER CAP

HOLE

SECONDARY

HOLE

BUTTON

Fig. 3

Page 10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Operators Manual Table of Contents IntroductionGeneral Safety Rules Read ALL InstructionsSpecific Safety Rules for Trimmer USE Specific Safety RulesSpecific Safety Rules for BRUSHCUT- TER and Blade USE Symbols Symbol Name ExplanationService Symbol Signal MeaningSpecifications UnpackingFeatures CS30 RY30020, RY30023SS30 RY30040, RY30043 Removing the Attachment from the Power Head AssemblyAttaching the Power Head to the Attachment Attaching the Storage HangerAttaching the Front Handle CS30 and SS30 Attaching the J Barrier Handle BC30To Attach the Curved Shaft Grass Deflector CS30 Attaching the Grass DeflectorAttaching the Brushcutter Guard BC30 To Attach the Straight Shaft Grass Deflector SS30Removing the TRI-ARC Blade Brushcutter Guard Attaching the Shoulder Harness BC30Converting from Brushcutter to String Trimmer BC30 See Figures 10Converting from String Trimmer to Brushcutter BC30 Installing the TRI-ARC Blade Brushcutter GuardRemoving the Straight Shaft Grass Deflector and String Head Fueling and Refueling the Trimmer OperationOperating the Trimmer Cutting Tips To Advance the Cutting LineTo Advance the Cutting Line Manually See Figures 16TRI-ARC Blade Operating the BrushcutterBlade Thrust Cutting Technique BladeTo Start a Cold Engine Starting and StoppingSee Figures 21 To Stop the EngineNEW Prewound Spool MaintenanceSpool Replacement See Figures 24String Replacement See Figures 26Replacing and Cleaning AIR Filter Cleaning the Exhaust Port and Muffler Spark ArrestorSee Figures 29 Spark Plug Fuel CAPStorage 1 Month or Longer Troubleshooting Problem Possible Cause SolutionCall Warranty Manufacturers Warranty CoveragePage Emissions Maintenance Schedule and Warranted Parts List Service
Top Page Image Contents