1. | Spacer | 5. | 3/8" Flat Washer | 10. | 3/8 x 1" Bolt |
2. | Leaf Mulcher | 6. | Baffle Mounting Lug | 11. | Angle Lug |
3. | 3/8" Nut | 7. | Center Baffle | 12. | 3/8 x |
4. | 3/8" Lock Washer | 9. | 3/8" Lock Nut | 13. | Side Shield |
Figure 33. Leaf Mulcher L59
On L59 installations, align attachment angles with third hole from front of mower and install between side shields and deck angle. Secure with 3/8 x 1" bolts.
On L306 installations, align attachment angles with fourth hole from front of mower and install between side shield and deck angle. Attach with 3/8 x 1-1/2" bolt and flanged lock nut. Use two 3/8" flat washers as shims between side shield and deck angle rear hole.
On L59 installations, insert three 3/8 x 1-1/2" bolts through holes drilled in front lip of mower. Insert a 5/8" pipe spacer on each bolt between deck and leaf mulcher. If pipe spacer is too long, substitute 3/8" washers for spacers.
On L306 installations, insert three 3/8 x 1" bolts through holes drilled in front lip of mower. Attach leaf mulcher directly to front lip of mower.
On L59 mowers, drill four 7/16" holes in mower deck using existing holes in leaf mulcher attachment plate as templates. On L306, only two holes are required.
Insert 3/8 x 1" bolts through these holes and secure with a lock washer and 3/8" nut
Tighten all bolts in leaf mulcher assembly.
Check blade clearance by turning each one by hand. Should a blade contact a mulcher ring, reshape the ring as necessary. Be sure to have 1/8" minimum clearance between blade tip and mulcher.
15148 (Rev. 2/9/2007) | Assembly 29 |
|
|
