Woods Equipment L59A-3 PRE-DELIVERY Check List, Delivery Check List, Optional Equipment Available

NOTICE

Alignment must be rechecked if it is neces- sary to move idler pulleys or the mower deck to get proper belt tension.

Tension on a new belt should be readjusted every half hour for the first two hours and then checked every eight hours of operation.

Figure 27. Proper Belt Tension

Rear Belt Shield Installation

Place stud welded on bottom of belt shield in small hole of idler bracket drawbar.

Install clevis pin through belt shield brackets and top link bracket.

Secure with safety pins.

PRE-DELIVERY CHECK LIST

(Dealer Responsibility)

Inspect the mower thoroughly after assembly to be cer- tain it is set up properly before delivering it to the cus- tomer. The following check list is a reminder of points to inspect. Check off each item as it is found satisfactory or after proper adjustment is made.

___	Check that all safety shielding is in place.
___	Check all bolts to be sure they are correctly
	torqued.
___	Check that all cotter pins are properly installed.
___	Lubricate all grease fittings; check to make sure a
	small amount of grease comes out of seal.
___	Check that blades have been properly installed.
___	Check mower attitude and belt alignment.

DELIVERY CHECK LIST

(Dealer Responsibility)

___ Show customer how to make adjustments.

___ Explain importance of lubrication and show cus- tomer lubrication points on tractor and mower.

___ Point out safety features and optional equipment.

___ Present Operator's Manual to customer and rec- ommend they become familiar with all sections.

OPTIONAL EQUIPMENT AVAILABLE

A leaf mulcher, low-suction blades, front roller, and casters are offered as optional equipment for this mower. Some options may not be available for some mountings.

Blades

Low-suction blades are optional for this mower. In sandy areas where abrasive action could cause exces- sive blade wear, low-suction blades are recommended.

Casters

Casters are used to adjust cutting height.

Leaf Mulcher

Bothersome leaf raking, bagging or burning can be minimized by equipping your mower with a leaf mulcher attachment. With this attachment, your mower will dispose of leaves by quickly and thoroughly shred- ding them. The shredded matter will decompose and form humus.

The use of standard-suction blades is recommended with the leaf mulcher. It is also recommended that the leaf mulcher be removed for grass mowing.

Adjust mower with blades approximately 1-1/2" above ground and with front of mower slightly higher than the rear. Operate tractor at a slow ground speed with the PTO at full rpm.

Front Roller

The front roller should be used when scalping occurs. Side skids and casters effectively reduce scalping in most cases.

You may encounter areas where the side skids or cast- ers will drop into depressions and allow the center of the mower to contact the ground and scalp. When this occurs, you should install a front roller in the center of the mower.

26 Assembly 15148 (Rev. 2/9/2007)