Ryobi RY09051 If Assistance is Required Starting this Product, Operating the Blower

Page 11

OPERATION

TO STOP THE ENGINE:

To stop the engine, depress and hold the STOP switch to the stop position “ ”.

HOT RESTART OF THE ENGINE:

Set the choke lever to the RUN position.

Lock throttle lever.

Pull the starter grip and rope until the engine runs.

IF ASSISTANCE IS REQUIRED STARTING THIS PRODUCT:

Do not return this product to the retail store where it was purchased. Please call our Customer Service Department for any issues you may have.

For Help Call: 1-800-860-4050

OPERATING THE BLOWER

See Figures 9 - 10.

WARNING:

Never run the unit without the blower tubes installed or the vacuum door securely closed. Use of an improperly assembled unit could result in serious personal injury.

Start the blower. Refer to Starting and Stopping earlier in this manual. Hold the blower with the upper handle in your right hand.

WARNING:

Always hold the blower away from your body with the handle in your right hand when operating as a blower, keeping clearance between your body and the product. The muffler side of the blower should be away from your body. Any contact with the housing can result in burns and/or other serious personal injury.

WARNING:

Conserve water by using power blowers instead of hoses for many lawn and garden applications, including areas such as gutters, screens, patios, grills, porches, and gardens.

Operate blower at the lowest possible throttle speed to do the job.

Check your equipment before operation, especially the muffler, air intakes, and air filters.

Use rakes and brooms to loosen debris before blowing.

In dusty conditions, slightly dampen surfaces when water is available.

Watch out for children, pets, open windows, or freshly washed cars, and blow debris safely away.

Hold blower, as shown in Figure 9, so the air stream can work close to the ground.

After using blowers or other equipment, CLEAN UP! Dispose of debris properly.

Use the sweeper nozzle for the everyday blowing opera- tion. This nozzle allows for more area to be covered during the blowing operation.

The high velocity nozzle is specifically designed for wet sticky leaves. It allows you to scrape wet leaves or debris while operating the blower.

CRUISE CONTROL

See Figure 11.

The cruise control can be used to operate the blower without holding the throttle trigger.

To engage the cruise control:

Pull cruise control lever back towards user, and stop at the desired throttle setting.

To release the cruise control, push cruise control lever all the way towards the front of unit.

VACUUM OPERATION

See Figure 12.

WARNING:

Do not place blower on top of or near loose debris or gravel. Debris may be sucked into blower intake vent resulting in possible damage to the unit and could result in serious personal injury.

To keep from scattering debris, blow around the outer edges of a debris pile. Never blow directly into the center of a pile.

Operate power equipment at reasonable hours only - not early in the morning or late at night when people might be disturbed. Comply with the times listed in local ordi- nances.

To reduce sound levels, limit the number of pieces of equipment used at any one time.

Never run the unit without the vacuum tubes and vacuum bag installed. Use of an improperly assembled unit could result in serious personal injury.

WARNING:

Keep the muffler and all hot surfaces of the blower/ vacuum away from your body. Failure to do so could result in possible serious personal injury.

Install the vacuum tubes and the bag. Refer to the ASSEMBLY section earlier in this manual.

Start the blower. Refer to Starting and Stopping earlier in this manual.

9 - English

Page 10 Page 12
Image 11
Page 10 Page 12
Contents ALL Versions Toutes LES Versions Todas LAS Versiones Save this Manual for Future ReferenceAseguramiento Proper Blower Operating Position Proper Vacuum Operating PositionIntroduction Table of Contents Table DES Matières / Índice DE ContenidoRead ALL Instructions General Safety RulesFueling Specific Safety RulesSymbol Signal Meaning SymbolsSymbol Name Explanation Assembly FeaturesAssembling the Blower Tubes Installing the Vacuum BAGInstalling the Vacuum Tubes Operation See Figures 9 If Assistance is Required Starting this ProductOperating the Blower Vacuum OperationCleaning the Exhaust PORT, Muffler and Spark Arrestor MaintenanceGeneral Maintenance Cleaning the AIR FilterStoring the Product TroubleshootingSpark Plug Replacement When storing 1 month or longerLimited Warranty Statement WarrantyEmissions Parts List MANUFACTURER’S Warranty CoverageOWNER’S Warranty Responsibilities Defect Warranty Coverage RequirementsThis Product WAS Manufactured with a Catalyst Muffler English AVERTISSEMENT  Règles DE Sécurité GénéralesConserver CES Instructions Approvisionnement EN Carburant Règles DE Sécurité ParticulièresSymbole NOM Explication SymbolesSymbole Signal Signification Assemblage CaractéristiquesAssemblage DES Tubes DE Soufflante Installation DU SAC À DébrisInstallation DES Tubes D’ASPIRATION Carburants Oxygénés UtilisationMélange DU Carburant Remplissage DU RéservoirChaud Relancer DU Motor Utilisation DE LA SoufflanteUtilisation DE L’ASPIRATEUR AVERTISSEMENT Voir la et EntretienNettoyage LE Filtre À AIR Entretien GénéralRemisage LE Produit Remplacement DE LA BougieDépannage Bouchon DU Réservoir AvertissementÉnoncé DE LA Garantie Limitée GarantieListe DE Pièces DU Système DE Contrôle D’ÉMISSIONS Durée DE LA Garantie DU FabricantCouverture Allumage Filtre À AIRCarburateur Réservoir DE CarburantAdvertencia Reglas DE Seguridad GeneralesGuarde Estas Instrucciones Abastecimiento DE Combustible Reglas DE Seguridad EspecíficasPrecaución SímbolosPeligro AdvertenciaArmado CaracterísticasInstalación DE LOS Tubos DE LA Aspiradora Lista DE EmpaquetadoMontaje DE LOS Tubos DE LA Sopladora Instalación DEL Saco DE LA AspiradoraFuncionamiento Si necesita asistencia llame al Manejo DE LA SopladoraManejo DE LA Aspiradora SI Necesita Asistencia Para EL ­ARRANQUE Este ProductoVea la figuras 13 y MantenimientoMantenimiento General Limpieza LA Filtro DE AireAlmacenamiento DE LA Producto Solución DE ProblemasTapa DEL Tanque DE Combustible Advertencia Reemplazo DE LA BujíaDeclaración DE LA Garantía Limitada GarantíaLista DE Piezas Para EL Control DE Emisiones Cobertura DE LA Garantía DEL FabricanteConjunto DEL Tanque DE Combustible Este Producto SE Fabricó CON UN Silenciador CatalíticoConjunto DE Silenciador Catalítico Conjunto DEL CarburadorCalifornia Propuesta DE LEY NÚM Manuel D’UTILISATION Manual DEL OperadorCalifornia Proposition Proposition 65 DE L’ÉTAT DE Californie

RY09051 specifications

The Ryobi RY09051 is a versatile and innovative power tool designed to cater to the needs of homeowners and DIY enthusiasts alike. This outdoor tool is primarily known for its functionality as a gasoline-powered pressure washer, boasting a range of features that make it a reliable choice for those seeking efficiency and performance in cleaning tasks.

One of the standout features of the Ryobi RY09051 is its robust 9,000 PSI engine, which allows it to tackle a variety of cleaning applications, from washing vehicles to clearing driveways and patios. The engine's impressive power ensures that dirt, grime, and stubborn stains are easily eliminated, providing exceptional cleaning results.

This pressure washer is equipped with a high-performance axial cam pump that optimizes water flow and pressure. This pump not only powers through tough cleaning jobs but also enhances durability, allowing the unit to perform optimally over time. The unit’s removable detergent tank is another significant advantage, enabling users to apply soap effectively during the cleaning process for even better results.

Portability is a crucial factor for outdoor tools, and the Ryobi RY09051 doesn’t disappoint. The unit features sturdy wheels that make it easy to maneuver across various terrains, and a lightweight design that ensures ease of transport. Additionally, the foldable handle provides convenient storage options, making it ideal for those with limited space.

User-friendliness is a hallmark of the RY09051, highlighted by its quick-connect nozzle system. This system allows for easy swapping between different nozzle sizes, thus offering users the flexibility to adjust the spray pattern according to their task. Whether you need a broad spray for rinsing off a large surface or a concentrated stream for those tougher spots, the Ryobi has you covered.

Finally, safety features are paramount when it comes to power tools, and the Ryobi RY09051 includes a safety trigger lock and a thermal relief system to prevent overheating. These features ensure that users can operate the pressure washer with confidence and peace of mind.

In summary, the Ryobi RY09051 stands out in the realm of gasoline-powered pressure washers due to its powerful performance, user-friendly design, and advanced features, making it an essential addition for anyone looking to achieve outstanding cleaning results in their outdoor spaces.
Top Page Image Contents