R
Section 2
2.5 Roll-over protection system
WARNING
The seat belt must be securely fastened during operation. Failure to do so could cause serious injury or loss of life.
This mower has been designed for good traction and stability under normal mowing conditions. However, caution must be used when traveling on slopes, especially when the grass is wet. Do not mow on wet grass. Wet grass reduces traction and steering control.
Any or all parts of the
The potential exposure of the seat belt to severe environmental conditions make it crucial to inspect the seat belt system regularly.
It is recommended that the seat belt be inspected on a daily basis for signs of damage. Any seat belt system that shows cuts, fraying, extreme or unusual wear, significant discoloration due to UV exposure, dirt or stiffness, abrasion to the seat belt webbing, or damage to the buckle, latch plate, hardware or any other obvious problem should be replaced immediately.
WARNING
Failure to properly inspect and maintain the seat belt can cause serious injury or loss of life.
1. Check the full length of the seat belt webbing for cuts, wear, fraying, dirt and stiffness. See Figure
2. Check the seat belt webbing in areas exposed to ultra violet rays from the sun or extreme dust or dirt. If the original color of the webbing in these areas is extremely faded and/or is packed with dirt, the physical strength of this webbing may have deteriorated. If this condition exists, replace the seat belt system.
3. Check the buckle and latch for proper operation and determine if the latch plate is excessively worn, deformed, or if the buckle is damaged or cracked. See Figure
6
INSPECT BUCKLE & LATCH
INSPECT WEBBING
Figure 2-1. Seat Belt Inspection
WARNING
Reduce speed when turning, operating on slopes, slick or wet surfaces. Allow extra distance to stop.
Stay off of slopes too steep for safe operation. To check a slope, attempt to back up it (with the cutter deck down). If the machine can not back up the slope without the wheels slipping, do not operate the machine on this slope. Under no circumstances should the machine be operated on slopes greater than 15 degrees.
DO NOT mow near
Operate the machine smoothly, no sudden turns, starts or stops on a slope.
NEVER tow on slopes. The weight of the towed equipment may cause loss of traction and loss of control.
DO NOT permit untrained personnel to operate the machine.
Be cautious when loading and unloading onto trailers or trucks.
Use only a full width ramp.
Ramp angle should be no more than 15 Degrees.
Back up the ramp and drive down forward.