Scag Power Equipment SFZ36-17KA, SFZ36-20BS, SFZ61-28BS Cutter Deck Height Adjustment

Section 6 R

LOOSEN HERE

ADJUST HERE

2007 SFZ RSDA

LOOSEN HERE

ADJUST HERE

2007 SFZ DLA

Figure 6-6. Cutter Deck Pitch Adjustment

- NOTE -

To prevent the cutter deck from teetering, all four

(4)cutter deck hanging chains must have tension on them. If all four chains do not have tension on them and the deck teeters, you must readjust the cutter deck as outlined in the procedures above. All measurements should be taken from the top edge of the deck as the deck has an uneven bottom edge.

Cutter Deck Height

The cutter deck height adjustment is made to ensure that the cutter deck is cutting at the height indicated on the cutting height index gauge.To check for proper deck height, be sure that the mower is on a flat, level surface and the tires are properly inflated.

1.Place the cutter deck in the 3" cutting position. Push on the cutter deck foot pedal and pull up on the cutter deck release lever to lower the cutter deck.

2.Check the measurement from the floor to the cutter blade tip. If the measurement is not 3", an adjustment can be made using the deck level links

3.Loosen the elastic stop nuts securing the deck level links on both sides of the cutter deck. See Figure 6-7.

LOOSEN HERE

ADJUST HERE

2007 SFZ RSDLA

Figure 6-7. Cutter Deck Height Adjustment

4.Turn the adjustment bolts equal amount of turns either clockwise to raise or counter-clockwise to lower the cutter deck until the measurement at the cutter blade is 3" on both sides..

5.Tighten the elastic stop nuts on the deck level links.

25