Scag Power Equipment SFZ36-17KA, SFZ36-20BS, SFZ61-28BS Troubleshooting Cutting Conditions Contd

Section 5

TROUBLESHOOTING CUTTING CONDITIONS (CONT'D)

R

Condition	Cause	Cure
U n e v e n C u t o n F l at	Lift worn from blade	Replace blade
Ground - Wavy High-Low
Appearance, Scalloped	Blade upside down	Mount with cutting edge toward ground
Cut, or Rough Contour
	Deck plugged, grass accumulation	Clean underside of deck
	Too much blade angle (deck pitch)	Adjust pitch and level
	Deck mounted improperly	See your authorized SCAG dealer
	Bent spindle area	See your authorized SCAG dealer
Width of Deck
SGB020	Dull blade	Sharpen blade

Uneven Cut on Uneven Ground-WavyAppearance, High-Low Scalloped Cut, or Rough Contour

	May need to reduce ground speed, raise
Uneven ground	cutting height, and/or change direction
	of cut

Width of Deck
SGB021
Sloping Ridge Across	Tire pressures not equal	Check and adjust tire pressure
Width of Cutting Path
	Wheels uneven	Check and adjust tire pressure
	Deck mounted incorrectly	See your authorized SCAG dealer

Deck not level side-to side Check for level and correct

Width of Deck

SGB023

19