RedMax HEZ2401S-CA, HEZ3001S-CA manual Fonctionnement Uso, Couple de serrage 51~68 in-lbs 6~8 N.m

Page 35

Français

 

Español

 

8. Fonctionnement

8. Uso

 

 

 

 

 

Les coupe-bordures RedMax sont conçus pour couper les bordures des pelouses de jardins, parcs, bordures de route, etc.

Avant de démarrer le moteur, mettez-vous en position d’utilisation et réglez la position de la poignée et la hauteur de la roue comme requis.

Los cortacéspedes Redmax están diseñados para recortar césped en jardines, parques, borde de la carretera y demás.

Antes de arrancar el motor, adopte la posición de funcionamiento y ajuste la posición del mango y la altura de la rueda como sea necesario.

REGLAGE DE LA HAUTEUR DE LA ROUE

AJUSTE DE LA ALTURA DE LA RUEDA

1.Desserrez l’écrou à oreilles et modifiez la hauteur de la roue pour obtenir la profondeur de coupe désirée. (OP1)

1.Afloje la tuerca de alas y cambie la altura de la rueda para obtener la profundidad de corte deseada. (OP1)

(1)

Coupe profonde

(1)

Corte profundo

(2)

Coupe peu profonde

(2)

Corte poco profundo

(3)

Ecrou à oreilles

(3)

Tuerca de alas

2.Après avoir ajusté la hauteur, serrez fermement l’écrou à oreilles.

Couple de serrage : 51~68 in-lbs (6~8 N.m)

2.Después de ajustar la altura, apriete la tuerca de alas de forma segura.

Par de torsión de apriete: 51~68 in-lbs (6~8 N.m)

AVERTISSEMENT

Ne réglez jamais la hauteur de la roue pendant que le moteur tourne.

MISE EN MARCHE DU MOTEUR

AVERTISSEMENT

Faire attention que la lame de coupe se mette à tourner dès que le moteur démarre.

1.Poser la machine dans un endroit plat et ferme. Ne pas poser la tête de coupe sur le sol et dégager tout objet pouvant être projeté par la lame qui se met à tourner dès que le moteur démarre.

2.Appuyer plusieurs fois sur la pompe d’amorçage jusqu’à ce que de l’essence s’écoule par le tuyau de trop-plein (OP2).

3.Placer le starter en position fermée (OP3).

4.Placer l’interrupteur de contact sur la position de démarrage “Marche”. Tout en tirant sur la manette d’accélérateur, appuyer sur le bouton de verrouillage pour libérer l’accélérateur, le placer alors sur la position de démarrage “Start”. (OP4)

5.Tout en maintenant fermement la machine, tirer la poignée de démarrage (OP5).

(1) levier du starter

(2) fermé

(3) ouvert

(4)

Interrupteur d’allumage

(5)

Marche

(6)

Arrêt

(7)

Bouton de blocage de l’accélérateur

ADVERTENCIA

No ajuste nunca la altura de la rueda con el motor en marcha.

ARRANQUE DEL MOTOR

ADVERTENCIA

Tenga presente que el cabezal cortador comenzará a girar cuando el motor sea arrancado.

1.Coloque la unidad sobre una superficie plana y firme. Asegúrese de que el cabezal cortador no esté en contacto con el suelo y manténgalo alejado de los objetos circundantes, ya que comenzará a girar cuando el motor arranque.

2.Pulse el cebador varias veces hasta que el combustible fluya por el tubo transparente. (OP2)

3.Mueva la palanca del estrangulador a la posición de cierre. (OP3)

4.Ajuste el interruptor de ignición a la posición “Iniciar”. Mientras tira de la palanca de aceleración, pulse el botón de bloqueo y libere el acelerador, a continuación el acelerador quedará fijado en la “Posición de arranque”. (OP4)

5.Mientras sujeta la unidad firmemente, tire rápidamente de la cuerda del arrancador hacia fuera hasta que el motor arranque. (OP5)

(1)

Palanca del estrangulador (2) cerrar

(3) abrir

(4) Interruptor de encendido

(5) inicio

(6) parada

(7)

Botón del grupo acelerador

35

Image 35
Contents OWNER/OPERATOR Manual Mode D’EMPLOI Manual DE Instrucciones Contents Advertencias Contenidas EN EL Manual Differents Types D’AVERTISSEMENT DE CE Mode D’EMPLOITables des matieres Contenido Parts location SpecificationsEspecificaciohes Emplacement des pieces Situación de las piezasFiche technique HEZ2602S/HEZ2602S-CA HEZ2602S/HEZ2602S-CA Fiche techniqueHEZ3001S/HEZ3001S-CA Especificaciones sujetas a cambios sin previo aviso Wear head, eye and ear protection MachineImportante HEZ2401S Symbols on the machinePosition Emission ControlControl DE Emisiones EmplacementPosición HEZ3001S-CA HEZ2602SHEZ2602S-CA HEZ3001SType de moteur 8HQZS BG EM*2 Cylindree du moteur 25cc Working Circumstance For safe operationWorking Condition Precauciones Consignes de securite Instrucciones de seguridadConditions DE Travail Condiciones DE TrabajoBefore Starting the Engine Working PlanAvant DE Mettre LE Moteur EN Marche Plan DE TravailPlan DE Trabajo DE LA MachineStarting the Engine Using the ProductUtilisation DE LA Machine USO DEL Producto Demarrage DU MoteurArranque DEL Motor If Someone Comes MaintenanceMantenimiento SI QUELQU’UN S’APPROCHEEntretien SI Alguien SE AproximaTransportation Handling FuelRefill after cooling the engine Llenar una vez que el motor se haya enfriado Manipulation DU CarburantTransport Manipulación DEL CombustibleSE2 Set upSE1 Mounting Other Parts Screw Clamp bolt Tightning Torque 70~130 in-lb 8~15 N.mMontage D’AUTRES Pieces Montaje DE Otras Partes Assemblage MontajeRecommended Mixing Ratio Gasoline 50OIL When using RedMax/ZENOAH genuine oilFuel Proporción DE LA Mezcla Recomendada Gasolina 50 Aceite Rapport DE Melange Recommande Essence 50 HuileCarburant Combustible Lors de l’utilisation de la véritable huile RedMax/ZENOAHFor Your Engine LIFE, Avoid HOW to MIX FuelFueling the Unit Abastecimiento DE LA Unidad Comment Obtenir UN BON Melange Como Mezclar EL CombustibleRemplissage DU Reservoir Eviter Pour Prolonger LA Duree DE VIE DU MoteurFuel Combustible SIN Aceite Gasolina Cruda OP2 OP3 OP4 Adjusting Wheel HeightOperation OP1Mise EN Marche DU Moteur Fonctionnement UsoCouple de serrage 51~68 in-lbs 6~8 N.m Par de torsión de apriete 51~68 in-lbs 6~8 N.mOP7 Adjusting Throttle CableAdjusting Idling Speed OP7 OP5 OP6Cómo Parar EL Motor OP4 Arret DU Moteur OP4Reglage Câble D’ACCÉLÉRATEUR Reglage DU Ralenti OP7OP8 HOW to USEComment Utiliser LE COUPE-BORDURES Como Usar Remarque NotaBe Sure to Check the Following Before Using Your Stick Edger MaintenanceMantenimiento EntretienMaintenance Chart Tabla DE Mantenimiento MantenimientoTableau D’ENTRETIEN Spark Plug MA1 MA2 MA3AIR Filter Fuel FilterEntretien Mantenimiento Gear Case Muffler MA4 MA5Spark Arrester Spark arresterParachispas Caja DE CambiosPARE-ETINCELLES Carter D’ENGRENAGECylinder Intake air cooling vent back MA6 Blade MA6Intake AIR Cooling Vent MA7 Toma DE Aire DE Refrigeración Ouïe DU Refroidissement PAR AIRMA8 Protector MA9 Procedures to be Performed After Every 100 Hours of USEStorage DisposalMise au rebut Eliminación Entretien MantenimientoRangement Almacenamiento Guide de localisation des pannes Troubleshooting guide12. Guía de localización y solución de problemas Nota Parts list Liste des pièces Lista de piezasParts list Pipe Comp Engine Unit HEZ2401S / HEZ2401S-CA S/N 70200101 and up Cylinder Comp Engine Unit HEZ2602S / HEZ2602S-CA S/N 70200101 and up Description Part Number Qty Engine Unit HEZ3001S / HEZ3001S-CA S/N 70200101 and up Part Number Description Qty Special ToolsOwner’s warranty responsibilities Manufacturer’s warranty coverageObligations du propriétaire liées à la garantie Couverture de la garantie constructeurResponsabilidades del propietario Cobertura de la garantía dada por el fabricanteLimited Warranty Garantie limitée Garantía Limitada Zenoah AMERICA, INC

HEZ3001S-CA, HEZ2602S-CA, HEZ2401S-CA specifications

The RedMax HEZ2401S-CA, HEZ2602S-CA, and HEZ3001S-CA series are advanced handheld gas-powered blowers designed for optimal performance and user convenience in commercial and residential landscaping. Each model in this series is tailored to meet the varying needs of users, while maintaining a focus on efficiency, ease of use, and effective air output.

The RedMax HEZ2401S-CA is an entry-level model, ideal for small to medium gardening tasks. This blower boasts a powerful 23.9 cc engine, delivering a reliable airspeed and an impressive air volume of up to 420 cubic feet per minute (CFM). Its lightweight design, weighing in at approximately 9.3 pounds, ensures easy mobility and reduced fatigue during extended use. The HEZ2401S-CA also features a comfortable harness system, allowing users to work for longer periods without discomfort.

Moving up to the HEZ2602S-CA, this model offers enhanced performance for more demanding applications. It comes equipped with a 25.4 cc engine, producing a higher airspeed and an increased CFM figure. The ergonomic handle design on the HEZ2602S-CA not only provides a secure grip but also reduces vibration, ensuring user comfort and control during operation. The blower is designed with a two-cycle engine that incorporates the company’s innovative engine technology to optimize fuel efficiency while minimizing emissions.

At the high end of the series, the HEZ3001S-CA stands out with its robust performance capabilities. Featuring a powerful 30.5 cc engine, this model is perfect for heavy-duty tasks and larger properties. Its impressive airflow capability, reaching up to 600 CFM, enables it to handle leaves, debris, and grass clippings with ease. The HEZ3001S-CA also integrates advanced anti-vibration technology, making it easier for professionals to manage without excessive strain on their hands and arms.

All three models share a commitment to durability and reliability, designed for longevity in rigorous working conditions. With their low noise output, these blowers are suitable for use in noise-sensitive environments. Furthermore, they are built with user-friendly features such as easy-start mechanisms, simplified air filter access for maintenance, and easy-to-reach controls for enhanced handling.

In conclusion, the RedMax HEZ2401S-CA, HEZ2602S-CA, and HEZ3001S-CA blowers combine power, efficiency, and user comfort, making them excellent tools for landscaping professionals and homeowners alike. With each model catering to different levels of power and functionality, users can select the perfect blower to meet their specific requirements.