Simplicity Complete Guide to Mower Drive and Deck Belt Diagrams and Replacements

Page 15

E

D

D E

A

B

Assembly

B

C

A

F

 

Figure 19. Install Turbo Blower

A.Pivot Pin

B.Deflector

C.Turbo

D.Anchor Bracket

E.Wingnut

F.Pivot Bracket

Install Turbo, Belt and Roller

1.Place the mower deck in the highest cut position.

2.Slide the pivot pin (A, Figure 19) into pivot bracket

(F).

3.Raise the deflector (B).

4.Rotate the turbo (C) and “latch” the slot in the turbo housing over and onto the anchor bracket

(D). Slot in mounting latch (A, gure 17 & 18) to be around outside nut. If not - reposition mounting latch on turbo. Tighten the wingnut (E) and cupwasher to secure turbo (C).

5.Attach the mower drive pulley to the mower deck drive pulley (B, Figure 20).

6.Pull back (away from deck) on belt tension lever

(C).

7.Install the turbo drive belt on pulleys as shown and release the belt tension lever (C).

8.Models With Rollers - Remove and discard the pushnut (B, Figure 21) and roller (A) from the right side of mower deck as shown.

9.Models With Rollers - Install the roller (A, Figure 22) and 5/8 pushnut (B) from the right side of mower deck as shown.

C

F

Figure 20. Turbo Belt Routing

A.Turbo Drive Belt

B.Mower Deck Drive Pulley

C.Belt Tension Lever

D.Idler Pulleys

E.Mower Deck Turbo Drive Pulley

F.Turbo Drive Pulley

B A

Figure 21. Remove Right Side Pushnut and Roller

A.Roller, Hollow

B.Pushnut, 5/8

B A

Figure 22. Install Right Side Pushnut and Roller

A.Roller, Solid

B.Pushnut, 5/8

14www.SimplicityMfg.com www.MasseyLawn.com www.AGCOLawn.com www.Snapper.com

Image 15
Contents OPERATOR’S Manual Table of Contents Preparation SafetySafety Decals Safety IconsHazard Safety Icon Attachment Identification Data Identification NumbersInitial Assembly Cover Flange Qty Description Remove Deflector and Arbor Cover All Models Install the Discharge BaffleInstall the Deflector Hinge, Bracket and Deflector Discard Taptite Screws Install Idler Assembly and Belt GuideRemove Hardware Locknut Spring Washers Pulley Spacer Install the Turbo Drive PulleyInstall Deflector Latch Install Up-Stop 38 MowersMounting Latch Holes Install Turbo Belt and Mounting LatchInstall Turbo, Belt and Roller Only Install Seal, Cover, tubes and TurboAssembly Twin Collectors Edging Triple Collector Plate and EdgingSnapper Models Install Thick Seal Edge of Thin SealInstall Set Collar Lift Rod Set Screw Rod Tip Normal Removal & Installation Normal Remocal & InstallationTurbo & Tube Installation Installation Normal RemocalTurbo & Tube Removal