A
B
E
C
D
Normal Remocal &
Figure 38. Connect Tube to Hood and Turbo
A.Seal
B.Discharge end of Tube Assembly
C.Clip
D.Nut and Capscrew
E.Intake end of Tube Assembly
Turbo & Tube Removal
1.Place the mower deck in the highest cut position.
2.Lift clip (C,Figure 38) over nut and capscrew and disconnect turbo from intake end of tube assembly.
Installation
WARNING
OPERATION WITHOUT TURBO, TUBE AND BAGGER
For operation without turbo, tube and bagger, the mower deflector MUST be properly installed in the down position and retained by the spring latch.
3.Slide the intake end of tube assembly (E) out of seal (A) and remove tube assembly.
4.Place the mower deck in the highest cut position.
5.Pull belt tension lever (C, Figure 37) away from the discharge opening to remove tension from the belt. Remove turbo drive belt.
6.Loosen wing nut (E, Figure 38) and lift deflector
(B). Rotate turbo (C) away from mower deck an remove.
7.Follow the Bagger Operator’s Manual for removal of catcher components.
21