Simplicity 1694924 manual Triple Collector Plate and Edging, Twin Collectors Edging

C	A
	D
C
	E
D
	A
E
B

Figure 28. Install Deflector Plate

A.Deflector Plate

B.Cover

C.New 7/32” Holes

D.Screws, #10-24 x 3/4

E.Locknuts, #10-24

Triple Collector - Plate and Edging

1.Hold deflector plate (A, Figure 28) in cover (B) as shown and mark new hole locations using deflector plate holes as a guide.

2.Drill two 7/32” holes in the locations marked in the previous step.

3.Secure deflector plate (A) to cover (B) using #10- 24 x 3/4 screws (D) and #10-24 locknuts (E).

4.From the inside of grass catcher slide the thick seal (A, Figure 29) starting at the LH side of the hinge edge (C) to the corner (B) on the cover edge as shown.

Twin Collectors - Edging

1.From the inside of grass catcher slide the thin seal (A, Figure 30) onto the cover edge (B) starting at the LH side of the hinge edge (D) so that the inside curl (C) is toward the inside of the cover .

2.From the inside of grass catcher slide the thick seal (A, Figure 5) on the cover edge as shown starting at the out side end of the thin seal (B) and continuing around the cover.

C
A	Assembly
B

Figure 29. Install Thick Seal

A.Thick Seal

B.Corner, LH

C.Hinge Edge

D

B

A

C

Figure 30. Install Thin Edging

A.Thin Edging

B.Cover Edge, LH

C.Inside Curl

D.Hinge Edge

17