| C |
Assembly | A |
| |
| B |
Figure 31. Install Thick Seal
A.Thick Seal
B.Edge of Thin Seal
A |
D |
C |
B |
Figure 32. Remove Lift Rod
A.Lift Rod
B.Lock Nut
C.Lift Bar
D.Special Nut
Snapper Models
1.Place several blocks of wood under the mower deck so that there is slack in the mower lift when the mower is in the lowest position.
2.Remove the hair pin (F, Figure 33) from lift rod (A).
3.Remove the lift rod (A, Figure 32 & 33) from lift bar
4.Remove the locknut (B, Figure 33), spacer (E).
5.Mark the location of the special nut (D) on lift rod
(A)and remove nut.
F
A
D 
C
E
B
Figure 33. Remove Lift Rod
A.Lift Rod
B.Locknut
C.Lift Bar
D.Special Nut
E.Spacer
F.Hair Pin
18www.SimplicityMfg.com www.MasseyLawn.com www.AGCOLawn.com www.Snapper.com