Husqvarna 327RD manual Assembling the cutting equipment

Page 15

ASSEMBLY

Assembling the cutting equipment

• Hook the blade guard/combination guard (A) onto the

fitting on the shaft and secure with the bolt.

!

WARNING!

When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting

CAUTION! Use the recommended blade guard. See

the Technical data section.

• Fit the drive disc (B) on the output shaft.

• Turn the blade shaft until one of the holes in the drive

disc aligns with the corresponding hole in the gear

housing.

• Insert the locking pin (C) in the hole to lock the shaft.

• Place the blade (D), support cup (E) and support

flange (F) on the output shaft.

• Fit the nut (G). The nut must be tightened to a torque

of 35-50 Nm (3.5-5 kpm). Use the socket spanner in

the tool kit. Hold the shaft of the spanner as close to

the blade guard as possible. To tighten the nut, turn

the spanner in the opposite direction to the direction

of rotation (Caution! left-hand thread).

! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.

Fitting a blade guard, grass blade and grass cutter

G

F

E

D

A B

C

Fitting the blade guard and saw blade

K

J

H

LI

A

•Remove the mounting plate (H). Fit the adapter (I) and bracket (J) with the two screws (K) as shown. Fit the blade guard (A) to the adapter using the 4 screws (L) as shown.

English – 15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents 323RII 327RX-series Symbols KEY to SymbolsContents Dear customer IntroductionWhat is what on the brush cutter? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentStop switch Cutting attachment guardVibration damping system Muffler Quick releaseCutting equipment Locking nutCutting equipment Sharpening grass cutters and grass blades Sharpening the saw bladeGeneral rules Trimmer head Assembly Fitting the handlebar 323RIIFitting the handlebar 327Rx, 327RDx Assembly Assembling and dismantling the two-piece shaft 327RDxDismantling Fit the nut G. The nut must be tightened to a torque Assembling the cutting equipmentFitting other guards and cutting attachments Correct height Adjusting the harness and brush cutterStandard harness Spreading the load on your shouldersFuel safety Fuel HandlingFuel Mixing FuelingStarting Starting and StoppingCheck before starting Starting and stoppingFor throttle handles with a start throttle lock StoppingStarter cord around your hand ABC of clearing Basic safety rulesWorking Techniques General working instructionsForestry clearing using a saw blade Brush cutting with a saw blade Grass trimming with a trimmer head Grass clearing using a grass bladeCarburetor MaintenanceMuffler Cooling systemRemember the risk of fire Two-piece shaft 327RDx Cleaning the air filterBevel gear Air filterSpark plug Maintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T25 Page Page Page Page Original instructions 1153290-95
Top Page Image Contents