Husqvarna 327RD manual Fitting other guards and cutting attachments

Page 16

ASSEMBLY

CAUTION! Use the recommended blade guard. See the Technical data section.

G

F

D

B

C

•Fit the drive disc (B) on the output shaft.

•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

•Place the blade (D) and support ﬂange (F) on the output shaft.

•Fit the nut (G). The nut must be tightened to a torque of 35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool kit. Hold the shaft of the spanner as close to the blade guard as possible. To tighten the nut, turn the spanner in the opposite direction to the direction of rotation (Caution! left-hand thread).

•When loosening and tightening the saw blade nut, there is a risk of injury from the teeth of the saw blade. You should therefore always ensure that your hand is shielded by the blade guard when doing this. Always use a socket spanner with a shaft that is long enough to allow this. The arrow in the diagram shows the area where you should operate the socket spanner when loosening or tightening the nut.

Fitting other guards and cutting attachments

•Fit the trimmer guard/combination guard (A) intended for use with the trimmer head/plastic blades. Hook the guard onto the ﬁtting on the shaft and secure it with the bolt (L).

B

C

A

A

•Fit the drive disc (B) on the output shaft.

•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

•Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.

H

H

•To dismantle, follow the instructions in the reverse order.

16 – English

Image 16

Contents 323RII 327RX-series KEY to Symbols SymbolsContents Introduction Dear customerWhat is WHAT? What is what on the brush cutter?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutCutting attachment guard Stop switchVibration damping system Quick release MufﬂerLocking nut Cutting equipmentCutting equipment Sharpening the saw blade Sharpening grass cutters and grass bladesGeneral rules Trimmer head Fitting the handlebar 323RII AssemblyFitting the handlebar 327Rx, 327RDx Assembling and dismantling the two-piece shaft 327RDx AssemblyDismantling Assembling the cutting equipment Fit the nut G. The nut must be tightened to a torqueFitting other guards and cutting attachments Adjusting the harness and brush cutter Standard harnessSpreading the load on your shoulders Correct heightFuel Handling Fuel safetyFuel Fueling MixingStarting and Stopping Check before startingStarting and stopping StartingStopping For throttle handles with a start throttle lockStarter cord around your hand Basic safety rules Working TechniquesGeneral working instructions ABC of clearingForestry clearing using a saw blade Brush cutting with a saw blade Grass clearing using a grass blade Grass trimming with a trimmer headMaintenance CarburetorCooling system MufﬂerRemember the risk of ﬁre Cleaning the air ﬁlter Bevel gearAir ﬁlter Two-piece shaft 327RDxSpark plug Maintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T25 Page Page Page Page Original instructions 1153290-95