Husqvarna 327RD manual Fueling, Mixing

Page 19

FUEL HANDLING

Mixing

•Always mix the gasoline and oil in a clean container intended for fuel.

•Always start by ﬁlling half the amount of the gasoline to be used. Then add the entire amount of oil. Mix (shake) the fuel mixture. Add the remaining amount of gasoline.

•Mix (shake) the fuel mixture thoroughly before ﬁlling the machine’s fuel tank.

•Do not mix more than one month’s supply of fuel at a time.

•If the machine is not used for some time the fuel tank should be emptied and cleaned.

	!	WARNING! The catalytic converter
	!	mufﬂer gets very hot during and after
		mufﬂer gets very hot during and after
		use. This also applies during idling. Be
		aware of the ﬁre hazard, especially when
		working near ﬂammable substances and/
		or vapours.

Fueling

WARNING! Taking the following

!precautions, will lessen the risk of ﬁre:

Do not smoke or place hot objects near fuel.

Always shut off the engine before refuelling.

Always stop the engine and let it cool for a few minutes before refuelling.

When refuelling, open the fuel cap slowly so that any excess pressure is released gently.

Tighten the fuel cap carefully after refuelling.

Always move the machine away from the refuelling area before starting.

•Clean the area around the fuel cap. Contamination in the tank can cause operating problems.

•Ensure that the fuel is well mixed by shaking the container before ﬁlling the tank.

English – 19

Image 19

Contents 323RII 327RX-series Symbols KEY to SymbolsContents Dear customer IntroductionWhat is what on the brush cutter? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentCutting attachment guard Stop switchVibration damping system Mufﬂer Quick releaseLocking nut Cutting equipmentCutting equipment Sharpening the saw blade Sharpening grass cutters and grass bladesGeneral rules Trimmer head Fitting the handlebar 323RII AssemblyFitting the handlebar 327Rx, 327RDx Assembling and dismantling the two-piece shaft 327RDx AssemblyDismantling Fit the nut G. The nut must be tightened to a torque Assembling the cutting equipmentFitting other guards and cutting attachments Correct height Adjusting the harness and brush cutterStandard harness Spreading the load on your shouldersFuel Handling Fuel safetyFuel Mixing FuelingStarting Starting and StoppingCheck before starting Starting and stoppingStopping For throttle handles with a start throttle lockStarter cord around your hand ABC of clearing Basic safety rulesWorking Techniques General working instructionsForestry clearing using a saw blade Brush cutting with a saw blade Grass trimming with a trimmer head Grass clearing using a grass bladeCarburetor MaintenanceCooling system MufﬂerRemember the risk of ﬁre Two-piece shaft 327RDx Cleaning the air ﬁlterBevel gear Air ﬁlterSpark plug Maintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T25 Page Page Page Page Original instructions 1153290-95