Husqvarna 327RD manual Starting and Stopping, Check before starting, Starting and stopping

Page 20

STARTING AND STOPPING

Check before starting

•Check the blade to ensure that no cracks have formed at the bottom of the teeth or by the centre hole. The most common reason why cracks are formed is that sharp corners have been formed at the bottom of the teeth while sharpening or that the blade has been used with dull teeth. Discard a blade if cracks are found.

•Check that the support flange is not cracked due to fatigue or due to being tightened too much. Discard the support flange if it is cracked.

•Ensure the locking nut has not lost its captive force. The nut lock should have a locking force of at least 1.5 Nm. The tightening torque of the locking nut should be 35-50 Nm.

•Check that the blade guard is not damaged or cracked. Replace the blade guard if it is exposed to impact or is cracked.

•Check that the trimmer head and trimmer guard are not damaged or cracked. Replace the trimmer head or

trimmer guard if they have been exposed to impact or are cracked.

•Never use the machine without a guard nor with a defective guard.

•All covers must be correctly fitted and undamaged before you start the machine.

Starting and stopping

WARNING! The complete clutch cover

!and shaft must be fitted before the machine is started, otherwise the clutch can come loose and cause personal injury.

Always move the machine away from the refuelling area before starting. Place the machine on a flat surface. Ensure the cutting attachment cannot come into contact with any object.

Make sure no unauthorised persons are in the working area, otherwise there is a risk of serious personal injury.The safety distance is 15 metres.

Starting

Primer bulb: Press the air purge repeatedly until fuel begins to fill the bulb. The bulb need not be completely filled.

20 – English

Page 19 Page 21
Image 20
Page 19 Page 21
Contents 323RII 327RX-series KEY to Symbols SymbolsContents Introduction Dear customerWhat is WHAT? What is what on the brush cutter?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutVibration damping system Stop switchCutting attachment guard Quick release MufflerCutting equipment Cutting equipmentLocking nut General rules Sharpening grass cutters and grass bladesSharpening the saw blade Trimmer head Fitting the handlebar 327Rx, 327RDx AssemblyFitting the handlebar 323RII Dismantling AssemblyAssembling and dismantling the two-piece shaft 327RDx Assembling the cutting equipment Fit the nut G. The nut must be tightened to a torqueFitting other guards and cutting attachments Adjusting the harness and brush cutter Standard harnessSpreading the load on your shoulders Correct heightFuel Fuel safetyFuel Handling Fueling MixingStarting and Stopping Check before startingStarting and stopping StartingStarter cord around your hand For throttle handles with a start throttle lockStopping Basic safety rules Working TechniquesGeneral working instructions ABC of clearingForestry clearing using a saw blade Brush cutting with a saw blade Grass clearing using a grass blade Grass trimming with a trimmer headMaintenance CarburetorRemember the risk of fire MufflerCooling system Cleaning the air filter Bevel gearAir filter Two-piece shaft 327RDxSpark plug Maintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T25 Page Page Page Page Original instructions 1153290-95
Top Page Image Contents