Husqvarna 327RD manual For throttle handles with a start throttle lock, Stopping

Page 21

STARTING AND STOPPING

Choke: Set the choke control in the choke position.

WARNING! When the engine is started

! with the choke in either the choke or start throttle positions the cutting attachment will start to rotate immediately.

Hold the body of the machine on the ground using your left hand (CAUTION! Not with your foot!). Grip the starter handle, slowly pull out the cord with your right hand until you feel some resistance (the starter pawls grip), now quickly and powerfully pull the cord. Never wrap the

starter cord around your hand

Repeat pulling the cord until the engine starts. When the engine starts. return choke control to run position and apply full throttle; the throttle will automatically disengage from the start setting.

CAUTION! Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. This can damage the machine.

CAUTION! Do not put any part of your body in marked area. Contact can result in burns to the skin, or electrical shock if the spark plug cap has been damaged. Always use gloves. Do not use a machine with damaged spark plug cap.

For throttle handles with a start throttle lock:

Set the throttle to the start position by first pressing the throttle lockout and the throttle trigger, then pressing the start throttle button (A). Then release the throttle lockout and the throttle trigger, followed by the start throttle button. The throttle function is now activated. To return the engine to idle, press the throttle lockout and throttle trigger again.

Stopping

Stop the engine by switching off the ignition.

CAUTION! The stop switch automatically returns to the start position. In order to prevent unintentional starting, the spark plug cap must be removed from the spark plug when assembling, checking and/or performing maintenance.

English – 21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents 323RII 327RX-series Symbols KEY to SymbolsContents Dear customer IntroductionWhat is what on the brush cutter? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentStop switch Cutting attachment guardVibration damping system Muffler Quick releaseCutting equipment Locking nutCutting equipment Sharpening grass cutters and grass blades Sharpening the saw bladeGeneral rules Trimmer head Assembly Fitting the handlebar 323RIIFitting the handlebar 327Rx, 327RDx Assembly Assembling and dismantling the two-piece shaft 327RDxDismantling Fit the nut G. The nut must be tightened to a torque Assembling the cutting equipmentFitting other guards and cutting attachments Standard harness Adjusting the harness and brush cutterSpreading the load on your shoulders Correct heightFuel safety Fuel HandlingFuel Mixing FuelingCheck before starting Starting and StoppingStarting and stopping StartingFor throttle handles with a start throttle lock StoppingStarter cord around your hand Working Techniques Basic safety rulesGeneral working instructions ABC of clearingForestry clearing using a saw blade Brush cutting with a saw blade Grass trimming with a trimmer head Grass clearing using a grass bladeCarburetor MaintenanceMuffler Cooling systemRemember the risk of fire Bevel gear Cleaning the air filterAir filter Two-piece shaft 327RDxSpark plug Maintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T25 Page Page Page Page Original instructions 1153290-95
Top Page Image Contents