Craftsman 104.79212 Tool KIT, Installing Cutting Attachment Shield, For Curved Shaft Trimmers

TOOL KIT

Your unit is provided with a tool kit (Fig.l). This tool kit consists of the following:

4 mm Allen Wrench

5 mm Allen Wrench

_¢// 8 & 10 mm Wrench

_ Four 5 mm Screws

(/_with captive washers

I_ FourWashers

Straight Shaft models	/_j_--k_J
include 2 Plate Washers	_
	Fig. 1

INSTALLING CUTTING ATTACHMENT SHIELD

Use the following instructions if the cutting attachment shield on your unit is not installed. Use only the instructions that apply to the type of shaft and shield that your unit is equipped with.

FOR CURVED SHAFT TRIMMERS

Place the cutting attachment shield and spacer against tube as shown in (Fig.2). Use the 2 screws provided

to clamp the cap and shield onto the tube. Tighten the screws evenly. Make sure the shield does not touch any rotating parts.

CuttingAttachment Shield

FOR STRAIGHT SHAFT TRIMMERS

Place the cutting attachment shield onto the shaft mount. Install using provided hardware in the sequence

as shown (Fig.3). Ji

Shaft Mount

\

II

I I

iCutting Attachment Shield

Plate Washer "'_ _

Washer _

Lock Washer Attachin( Screws

Fig. 3

INSTALLING THE UPPER HANDLE AND SAFETY BAR

1.Locate the 4 screws included in the tool kit.

2.Assemble the upper handle, safety bar and 4 attaching screws as shown in (Fig.4). Position the handle parts evenly over the rubber sleeve on shaft. Do not com- pletely tighten.

3.While holding the unit in the operating position (Fig. 14), position the upper handle to the location that pro- vides you the best grip.

4.Tighten the clamp screws evenly, until the upper handle is secure.

Attaching

Screws "_'_I _ g

	(_jk.1U	pper Handle
__u		bber_Sleeve
SafetyBar	_ I _"_._-_
	Fig. 4
	WARNING:

To prevent serious injury, never operate the

trimmer without the cutting attachment

in place.

Fig. 2