Black & Decker DR260BR, BDCD220RSR Assembly & Adjustment, Assembly Tools Required not Supplied

ASSEMBLY & ADJUSTMENT

ASSEMBLY TOOLS REQUIRED (NOT SUPPLIED):

- Phillips Screwdriver

INSTALLINGTHE GUARD

WARNING: REMOVE THE BATTERYFROM THE TOOL BEFORE ATTEMPTING TO ATTACH THE GUARD, EDGE GUIDE OR HANDLE. NEVER OPERATE TOOL WITHOUT GUARD FIRMLY IN PLACE. THE GUARDMUSTALWAYSBE ON THETOOL TO PROTECTTHE USER.

ATTACHING THE AUXILIARY HANDLE
• To attach the handle, press	6
in on the buttons (f) on both	f
sides of the upper housing
as shown in figure 6.

•Turn the trimmer upside down so that you are looking down at the spool cap (a).

•Turn the guard (b) upside down and slide it onto the motor housing (c). Make sure the tabs (d) on the guard engage the ribs (e) on the motor housing as shown.

•Continue to slide the guard on until you hear it “snap” into place.

•Using a phillips screw- driver, insert the guard screw as shown in figure 5 to complete the guard assembly.

•Once the guard is installed, remove the covering from the line cut-offblade, located on the edge of the guard

4	b
	c
d
	e
	a
5

• Position the handle as

shown in figure 7 (with the 7 Black & Decker logo facing upward). Partially push the handle on so that it will hold the buttons in when you release them with your

hand.

7