Black & Decker LST220 Replacement accessories, Cutting Line / Line Feeding, Replacing The Spool

Page 10

Cutting Line / LINE FEEDING

Your trimmer uses .065 inch (1.65 mm) diameter, ROUND nylon line. During use, the tips of the nylon lines will become frayed and worn and the special self feeding spool will automatically feed and trim a fresh length of line. Do not bump unit on ground in attempt to feed line or for any other purposes. Cutting line will wear faster and require more feeding if the cutting or edging is done along sidewalks or other abrasive surfaces or heavier weeds are being cut.

replacement accessories

CAUTION: Before you begin trimming, only use the appropriate type of cutting line.

Use BLACK+DECKER replacement spool Model No. AF-100. Reload nylon line (either bulk or prewound replacement spool) as shown in this manual.

• USE ONLY .065 inch (1.65 mm) DIAMETER ROUND NYLON MONOFILAMENT LINE. Do not use serrated or heavier gauge line, as they will overload the motor and cause overheating. This line is available at your local dealer or authorized service center.

• Other replacement parts (guards, spool caps, etc.) are available through BLACK+DECKER service centers. To find your local service location call: 1-800-544-6986 or visit www. blackanddecker.com.

WARNING: The use of any accessory not recommended by BLACK+DECKER for use with this tool could be hazardous.

REPLACING THE SPOOL

12

 

(figures 12,13,14)

 

• Remove battery from

Replacement

l

tool.

• Depress the tabs (k) and

spool

 

remove the spool cap (l) from

Model #

 

the spool housing (m) in the

 

trimmer head (figure 12).

AF-100

 

• For best results, replace

 

spool with BLACK+DECKER

 

 

model # AF-100.

k

k

• Grasp empty spool with one

hand and spool housing with

 

 

other hand and pull spool out.

 

m

• If lever (n) (figure 13) in

 

 

base of housing becomes

 

 

dislodged, replace in correct

 

 

position before inserting new

13

n

spool into housing.

• Remove any dirt and grass

 

p

from the spool and housing.

 

• Unfasten the end of the

 

 

cutting line and guide the line

 

 

into the eyelet (o) figure 14.

 

 

• Take the new spool and

 

 

push it onto the boss (p)

 

 

(figure 13) in the housing.

 

 

Rotate the spool slightly until it

 

 

is seated.

 

 

The line should protrude

 

 

approximately 5-3/8 inches

 

 

(136mm) from the housing.

 

 

• Align the tabs on the spool cap with the slots (q) in the housing

(figure 14).

 

 

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents 20V MAX* trimmer/edger Safety Guidelines Definitions To Reduce Risk of InjurySymbols Important Safety Instructions FOR BATTERY CHARGERS FOR BATTERY PACKS Storage RecommendationsFunctional Description Important Charging NotesAssembly & Adjustment Height adjustment Attaching the Auxiliary HandleOperating Instructions Switching on and offCONVERT TO EDGING MODE Cutting Line / Line Feeding Replacement accessoriesREPLACING THE SPOOL Rewinding Spool from Bulk Line REPLACING THE SPOOL Rbrc SealService Information MaintenanceTroubleshooting Tool runs slowlyTwo-YEAR Limited Warranty Mode D’EMPLOI Lignes directrices en matière de sécurité définitions Conserve Estas Instrucciones Symboles SuivantsDirectives DE Sécurité Importantes Pour LES BLOCS-PILES BLACK+DECKERComposants Pile laissée dans le chargeur Procédure de chargeUtilisation pour prolonger leur durée de vie Remarques importantes sur le chargementPARE-MAIN Solidement Insertion et retrait du Bloc-pilesUtiliser L’OUTIL Sans LE Fixation de la poignée auxiliaireDirectives d’utilisation Réglage de la HauteurMise en marche et arrêt Convertir AU Mode COUPE-BORDUREMise EN Garde Le Fil tranchant / Avance DU FILUtiliser uniquement un fil Rond de 1,7 mm 0,065 po Remplacer LA BobineRembobinage DE LA Bobine Avec DU FIL EN Vrac De diamètre figures 15, 16Bobine » EntretienLe sceau Srprcmc Information sur les réparations AccessoiresDépannage ’outil fonctionne lentementGarantie Limitée DE Deux ANS DE Podadora / Bordeadora 20V MAX Manual DE InstruccionesPautas DE SEGURIDAD/DEFINICIONES Page Conserve Estas Instrucciones Antes de limpiarlo, desconecte el cargador del tomacorriente Nunca intente conectar 2 cargadores juntosDescripción De cat Recomendaciones con respecto al almacenamientoProcedimiento de carga Notas importantes sobre la cargaInstalaciÓn del protector- figura Ensamblado RegulacionesOpere LA Herramienta SIN EL Protector Adecuadamente Ajuste de Altura Instrucciones de operaciónEncendido y apagado Cuerda de corte/ALIMENTACIÓN DE LA Cuerda Accesorios DE RepuestoConversión AL Modo DE Bordeado Blackanddecker.comEnrollado DEL Carrete CON Cuerda a Granel Precaución Para evitarReemplazo DE Carretes figuras 12,13,14 Reemplazo DEL CarreteLa herramienta funciona lentamente Detección de problemasMantenimiento En la figuraInformación de mantenimiento El sello Rbrc Garantía Limitada DE Dos AñosPage Page Page Solamente Para Propositos DE Mexico
Related manuals
Manual 44 pages 52.53 Kb Manual 44 pages 9.18 Kb

LST220R, LST220 specifications

The Black & Decker LST220R and LST220 are two innovative and powerful cordless string trimmers designed to make yard work easier and more efficient. These models cater to homeowners who want a flexible and lightweight solution for maintaining their lawns and gardens. Both trimmers share many features, making them reliable choices for tackling grass, weeds, and overgrown areas.

One of the standout features of the LST220R and LST220 is their 20-volt lithium-ion battery, which provides ample power and runtime needed for various trimming tasks. This battery technology ensures longer battery life and minimal self-discharge, allowing users to recharge and get back to work quickly. The trimmers come equipped with a 12-inch cutting swath, allowing for a wide trimming path that is efficient for medium to small-sized yards.

The innovative automatic feed spool system is another highlight, eliminating the hassle of manual line adjustments. This feature automatically feeds the cutting line as needed, ensuring a continuous, hassle-free operation while trimming. The dual-line design offers enhanced cutting performance, making it even easier to tackle tougher vegetation without compromising efficiency.

Ergonomics are a significant focus in the design of the LST220R and LST220. With their lightweight construction, these trimmers are easy to maneuver, reducing user fatigue during extended use. The adjustable height feature allows users to customize the trimmer's length, accommodating different user preferences and providing comfort while operating.

Moreover, both models come with the capability to convert from a trimmer to an edger, giving users greater versatility and functionality in one compact tool. The easy-to-use conversion feature allows for seamless switching between trimming and edging tasks, making it an excellent choice for those who want to ensure a neat and tidy lawn.

In summary, the Black & Decker LST220R and LST220 are excellent cordless trimmers that combine power, convenience, and versatility. With their efficient lithium-ion battery, automatic feed spool, lightweight design, and easy conversion to an edger, these trimmers make yard maintenance tasks less daunting. Homeowners can rely on these tools to keep their outdoor spaces looking pristine throughout the growing season.
Top Page Image Contents