Briggs & Stratton 020274-0 manual Warranties, Emissions Control System Warranty

Page 25

Warranties

Emissions Control System Warranty

Briggs & Stratton Corporation (B&S), the California Air Resources Board (CARB) and the United States Environmental Protection Agency (U.S. EPA)

Emissions Control System Warranty Statement (Owner’s Defect Warranty Rights and Obligations)

California, United States and Canada Emissions Control Defects Warranty Statement

The California Air Resources Board (CARB), U.S. EPA and B&S are pleased to explain the Emissions Control System Warranty on your small off-road engine (SORE). In California, new small off-road engines model year 2006 and later must be designed, built and equipped to meet the State’s stringent anti-smog standards. Elsewhere in the United States, new non-road, spark-ignition engines certified for model year 1997 and later must meet similar standards set forth by the U.S. EPA. B&S must warrant the emissions control system on your engine for the periods of time listed below, provided there has been no abuse, neglect or improper maintenance of your small off-road engine.

Your emissions control system includes parts such as the carburetor, air cleaner, ignition system, fuel line, muffler and catalytic converter. Also included may be connectors and other emissions related assemblies.

Where a warrantable condition exists, B&S will repair your small off-road engine at no cost to you including diagnosis, parts and labor.

Briggs & Stratton Emissions Control Defects Warranty Coverage

Small off-road engines are warranted relative to emissions control parts defects for a period of two years, subject to provisions set forth below. If any covered part on your engine is defective, the part will be repaired or replaced by B&S.

Owner’s Warranty Responsibilities

As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your Operating and Maintenance Instructions. B&S recommends that you retain all your receipts covering maintenance on your small off-road engine, but B&S cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

As the small off-road engine owner, you should however be aware that B&S may deny you warranty coverage if your small off-road engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications.

You are responsible for presenting your small off-road engine to an Authorized B&S Service Dealer as soon as a problem exists. The undisputed warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you should contact a B&S Service Representative at (414) 259-5262.

The emissions warranty is a defects warranty. Defects are judged on normal engine performance. The warranty is not related to an in-use emissions test.

Briggs & Stratton Emissions Control Defects Warranty Provisions

The following are specific provisions relative to your Emissions Control Defects Warranty Coverage. It is in addition to the B&S engine warranty for non-regulated engines found in the Operator’s Manual.

1.Warranted Parts

Coverage under this warranty extends only to the parts listed below (the emissions control systems parts) to the extent these parts were present on the engine purchased.

a.Fuel Metering System

•Cold start enrichment system (soft choke)

•Carburetor and internal parts

•Fuel Pump

•Fuel line, fuel line fittings, clamps

•Fuel tank, cap and tether

•Carbon canister

b.Air Induction System

•Air cleaner

•Intake manifold

•Purge and vent line

c.Ignition System

•Spark plug(s)

•Magneto ignition system

d.Catalyst System

•Catalytic converter

•Exhaust manifold

•Air injection system or pulse valve

e.Miscellaneous Items Used in Above Systems

•Vacuum, temperature, position, time sensitive valves and switches

•Connectors and assemblies

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Operator’s Manual Pressure Washer Where to Find UsEngine Date PurchasedTable of Contents Safety Rules Operator SafetyHazard Symbols and Meanings Equipment DescriptionOperate pressure washer only outdoors Certain components in this product and relatedContact with muffler area can result in serious burns Broken bones, fractures, bruises, or sprains could resultUnintentional sparking can result in fire or electric shock High pressure spray may damage fragile items including glass Risk of eye injury Spray can splash back or propel objectsAttach Handle and Accessory Tray AssemblyUnpack Pressure Washer Items in the carton includeAdd Fuel Add Engine OilFuel must meet these requirements High AltitudeConnect Hose and Water Supply to Pump Checklist Before Starting EngineOil Drain Drain engine oil here Features and ControlsPressure Washer Location OperationClearances and Air Movement How to Start Your Pressure Washer Lever to Choke position, then to Run position How to Stop Your Pressure WasherHow to Use ProjectPro Nozzles How to Use Accessory TrayFollow these instructions to change ProjectPro nozzles Usage Tips Cleaning and Applying DetergentTo apply detergent, follow these steps Pressure Washer Rinsing Cleaning Detergent Siphoning TubeAutomatic Cool Down System Thermal Relief For RinsingMaintenance Schedule MaintenancePressure Washer Maintenance Ring Maintenance Nozzle MaintenanceCheck High Pressure Hose Check Detergent Siphoning TubeOil Oil Recommendations Engine MaintenanceChecking Oil Level Adding Engine OilTo service the air cleaner, follow these steps Service Air CleanerService Spark Plug Install spark plug and tighten firmlyAir Cooling System After Each UseKeep areas within heavy line clear of debris Long Term Storage Winter StorageProblem Cause Correction TroubleshootingOwner’s Warranty Responsibilities Emissions Control System WarrantyWarranties Emission Information MaintenanceClaims and Coverage Exclusions Limited Warranty Common Service Parts Product Specifications800 Manual del Operario Limpiadora a Presión Dónde encontrarnosMotor Fecha de compraSeguridad de Operario Resolución de problemas GarantíasMontaje Características y mandos OperandoDerscripción del equipo Seguridad de OperarioReglas de seguridad Símbolos de Peligro y SignificadosRiesgo de electrocución AdvertenciaCuando Pruebe LA Bujía DEL Motor Aviso Desembale la limpiadora a presión MontajeConecte el manubrio y bandeja accesoria Los artículos que se encuentran en la caja sonAgregue combustible Agregar aceite al motorEl combustible debe reunir los siguientes requisitos Gran altitudLista de revision previa al arranque del motor Conecte la manguera y el suministro de agua a la bombaProporcione el suministro de agua adecuado Usar cuatro boquillas diferentes Características y mandosUbicación del limpiadora a presión OperandoCómo darle arranque a su máquina limpiadora a presión Espacio libre alrededor del limpiadora a presiónAhogado Choke Cuando arranque el motor, mueva lentamente la Cómo detener su máquina limpiadora a presiónRepite los pasos 11 por Cómo usar las boquillas ProjectPro Utilización de la bandeja de accesoriosLa Presión Baja La Presión AltaElija la boquilla ProjectPro que desee Limpieza y aplicación del detergenteUso inclina Para aplicar el detergente, siga los siguientes pasosLimpieza del tubo de inyección de detergente Enjuage de la máquina limpiadora a presiónSistema de enfriamiento automático alivio térmico Para EnjuagePlan de mantenimiento MantenimientoMantenimiento de la limpiadora a presión Revise la manguera de alta presión Revise y limpie el colador de entradaChequee el tubo de sifón del detergente Revise la pistola y la extensión para boquillasMantenimiento de los anillos o Mantenimiento del motorAceite Recomendaciones sobre el aceite Comprobación del nivel de aceiteAsegúrese de que la unidad esté en una superficie plana Cambio de aceite del motorServicio del depurador de aire Servicio del bujíaServicio del apagachispas Despues de cada usoSistema de refrigeración de aire Almacenamiento prolongado Almacenamiento para inviernoProblema Causa Solución Resolución de problemasResponsabilidades de la garantía del propietario Garantía del sistema de control de emisionesInformación sobre emisiones Garantía Limitada Servicio común despide Especificaciones del productoTemperatura del suministro

020274-0 specifications

Briggs & Stratton 020274-0 is a highly regarded portable generator that provides reliable power solutions for a variety of applications, including recreational activities, job sites, and emergency backup needs. This generator is known for its robustness, efficiency, and user-friendly design, making it a go-to choice for many consumers.

One of the key features of the Briggs & Stratton 020274-0 is its powerful engine. Equipped with a reliable 210cc OHV engine, it delivers a peak power output of 3,300 watts and a running power of 2,650 watts. This capacity is sufficient for running essential household appliances during power outages or providing energy for tools and equipment on job sites. The generator offers both 120V and 120/240V outlets, ensuring versatility for various applications.

Another notable characteristic of this generator is its lightweight and compact design. Weighing in at approximately 68 pounds, it is relatively easy to transport and maneuver, thanks to its integrated handle and rugged wheels. This portability feature is essential for users who need to move the generator between locations frequently.

The Briggs & Stratton 020274-0 also incorporates advanced technologies aimed at enhancing efficiency and performance. The generator utilizes a surge protection feature that safeguards connected devices from power surges, ensuring their longevity and reliability. Additionally, it features an automatic idle control system that reduces fuel consumption by lowering engine speed when not in use, thereby extending the runtime and minimizing operational costs.

The generator is designed with user convenience in mind. The control panel is intuitively laid out, providing easy access to power outlets and switches. The fuel tank has a generous capacity of 1.5 gallons, offering a runtime of up to 9 hours at a 25% load, making it ideal for longer use without the need for frequent refueling.

Moreover, the Briggs & Stratton 020274-0 comes with a range of safety features, including a low-oil shutdown system that prevents engine damage by automatically shutting off the generator when oil levels fall below a safe threshold. This feature extends the life of the generator and ensures dependable performance over time.

In summary, the Briggs & Stratton 020274-0 portable generator stands out with its powerful performance, user-friendly features, and advanced technologies. Its reliability, ease of use, and safety mechanisms make it an excellent choice for both home and professional use, delivering peace of mind when you need power the most.
Top Page Image Contents