Zenoah HTZ2401L, HTZ2401-CA Manufacturer’s warranty coverage, Owner’s warranty responsibilities

Page 50

CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT

YOUR WARRANTY RIGHTS AND OBLIGATIONS

The California Air Resources Board and ZENOAH AMERICA, INC. are pleased to explain the emission control system warranty on your 2007 and later small off-road engine. In California, new small off-road engines must be designed, built and equipped to meet the state’s stringent anti-smog standards. ZENOAH AMERICA, INC. must warrant the emission control system on your small off-road engine for the periods of time listed below provided there has been no abuse, neglect or improper maintenance of your small off-road engine.

Your emission control system may include parts such as the carburetor, fuel tank and the ignition system.

Where a warrantable condition exists, ZENOAH AMERICA, INC. will repair your small off-road engine at no cost to you including diagnosis, parts and labor.

Manufacturer’s warranty coverage:

The 2007 and later small off-road engines are warranted for two years. If any emission- related part on your engine is defective, the part will be repaired or replaced by ZENOAH AMERICA, INC.

Owner’s warranty responsibilities:

As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your owner’s manual. ZENOAH AMERICA, INC. recommends that you retain all receipts covering maintenance on your small off-road engine, but ZENOAH AMERICA, INC. can not deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

As the small off-road engine owner, you should be aware, however, that ZENOAH AMERICA, INC. may deny you warranty coverage if your small off-road engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modification.

You are responsible for presenting your small off-road engine to a ZENOAH AMERICA, INC. distribution center as soon as a problem exists. The warranty repairs should be completed in e reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you should contact ZENOAH AMERICA, INC. at (770)-381-5147 or you can write to

ZENOAH AMERICA, INC.

1100 Laval Blvd. Suite 110

Lawrenceville, Georgia 30043

HTZ2401-CA, HTZ2401L-CA, CHTZ2401-CA, CHTZ2401L-CA only

Image 50
Contents OWNER/OPERATOR Manual Mode D’EMPLOI Manual DE Instrucciones Contents Advertencias Contenidas EN EL Manual Differents Types D’AVERTISSEMENT DE CE Mode D’EMPLOITables des matieres Contenido Model SpecificationsParts location Especificaciohes Emplacement des pieces Situación de las piezasFiche technique ModeloSymbols on the machine Emplacement PosiciónWorking Circumstance For safe operationWorking Condition Circunstancias DE Trabajo Conditions DE TravailCondición DE Trabajo Working Plan Before Starting the EnginePlan DE Trabajo Plan DE TravailAvant DE Mettre LE Moteur EN Marche Antes DE Arrancar LA MáquinaUsing the Product Starting the EngineUtilisation DE LA Machine Demarrage DU MoteurArranque DE LA Máquina Empleo DEL ProductoIf Someone Comes MaintenanceManual SI SE Acerca Alguien SI QUELQU’UN S’APPROCHEEntretien MantenimientoTransportation Handling FuelRefill after cooling the engine Manejo DEL Combustible Manipulation DU CarburantTransport Llenar una vez que el motor se haya enfriadoRecommended Mixing Ratio Gasoline 50OIL When using RedMax/ZENOAH genuine oilFuel Proporción DE LA Mezcla Recomendada Gasolina 50 Aceite Rapport DE Melange Recommande Essence 50 HuileLors de l’utilisation de la véritable huile RedMax/ZENOAH Al utilizar el aceite auténtico de RedMax/ZENOAHHOW to MIX Fuel Fueling the UnitRemplissage DU Reservoir Abastecimiento DE LA Unidad Comment Obtenir UN BON MelangeComo Mezclar EL Combustible For Your Engine LIFE, Avoid Eviter Pour Prolonger LA Duree DE VIE DU Moteur Para Contribuir a LA Vida Útil DEL MOTOR, EviteStarting Engine OperationOP3 7 6 Cutting head will start moving upon the engine startsFonctionnement Uso Running in the Engine Adjusting Idling SpeedStopping Engine OP3 Air filterReglage DU Ralenti Arret DU MoteurFonctionnement DU Moteur Apagado DEL MotorDo not press the throttle during this operation HOW to USEHandle CHTZ2401/CHTZ2401-CA only Handle Locking leverProcedure Dutilisation Manette CHTZ2401/CHTZ2401-CA Cómo UsarHorizontal cut Hedge Trimming TechniquesVertical cut Corte vertical Coupe horizontaleTécnicas DE Recorte Corte horizontalMaintenance Maintenance ChartTableau D’ENTRETIEN Tabla DE MantenimientoFuel Filter Replacement Plug is NGK CMR7H or Champion RZ7CAIR Filter Spark PlugBougie D’ALLUMAGE Filtre a AIRFiltre a Carburant Filtro DE AireIntake AIR Cooling Vent BladesVentilación DE Refrigeración DEL Aire DE Admisión Ouïe DE Refroidissement PAR AIRLames CuchillasReduction Gearbox Safety Lock MA7Sharpening MA8 Verrou DE Sécurité MA7 Dispositivo DE Seguridad MA7 Affûtage MA8Afilado MA8 Reducteur MA9Disposal Procedures to be Performed After Every 100 Hours of USEStorage ANTI-VIBRATION SystemAlmacenamiento Entretien MantenimientoRangement Guide de localisation des pannes Troubleshooting guide11. Guía de localización y solución de problemas Nota RemarqueParts list Cutting Unit HTZ2401/HTZ2401-CA HTZ2401-L/HTZ2401-L-CA S/N Parts list CHTZ2401-L/CHTZ2401-L-CA Parts list Cylinder Comp Manufacturer’s warranty coverage Owner’s warranty responsibilitiesCouverture de la garantie constructeur Obligations du propriétaire liées à la garantieCobertura de la garantía dada por el fabricante Responsabilidades del propietarioLimited Warranty Garantie limitée Garantía Limitada Control DE Emisiones Emission ControlMesures DE Lutte Contre LES Emissions CHTZ2401-CA/CHTZ2401L-CA

CHTZ2401L, CHTZ2401, HTZ2401, HTZ2401-CA, HTZ2401L specifications

The Zenoah CHTZ2401, CHTZ2401L, HTZ2401L, HTZ2401, and HTZ2401-CA are a series of high-performance two-stroke engines designed for a variety of applications, including outdoor power equipment, gardening tools, and professional-grade machinery. These engines are renowned for their reliability, power output, and advanced features.

One of the main features of the Zenoah CHTZ2401 series is its powerful engine capacity. With a displacement of 24 cc, these engines deliver impressive power while remaining lightweight, making them suitable for handheld equipment. The CHTZ2401 and its variations provide a balance between performance and fuel efficiency, allowing users to work longer without frequently refueling.

A standout characteristic is the incorporation of Zenoah's advanced engine technologies. The engines are designed with a high compression ratio, which enhances combustion efficiency. This results in improved torque and power delivery, ensuring that the equipment can handle demanding tasks with ease. Additionally, the engines feature a unique exhaust system that minimizes emissions while maximizing power output, aligning with modern environmental standards.

The CHTZ2401 series also includes enhanced cooling systems, ensuring that the engines maintain optimal operating temperatures even during prolonged use. This feature is crucial in preventing overheating and extending the lifespan of the equipment. The lightweight design of these engines, often constructed with durable yet lightweight materials, contributes to the overall functionality and ease of use, especially for handheld applications.

Another important aspect is maintenance. The Zenoah engines are designed for easy access to components that require regular servicing, such as air filters and spark plugs. This user-friendly design lowers downtime and makes maintenance more convenient for users, whether they are professionals or casual gardeners.

In summary, the Zenoah CHTZ2401, CHTZ2401L, HTZ2401L, HTZ2401, and HTZ2401-CA engines represent cutting-edge technology in the realm of two-stroke engines. With their powerful performance, improved efficiency, and easy maintenance features, they are suitable for a wide range of applications, from landscaping to construction. As a result, they have become a popular choice among professionals who demand reliability and performance from their outdoor power equipment.