General Safety Information

DESCRIPTION

The Sta-Rite Sink Pump System, Model Number DP233110V-01, is ideal for home wastewater removal from beautician or utility sinks and wet bars, and for drain water transfer from air conditioners or dehumidifiers.

1/3 HP submersible pump unit is equipped with a 3-prong grounding-type power cord. Motor is oil-filled (dielectric oil) and sealed for cooler running. Upper sleeve/lower ballbearing on motor shaft never need lubrication. Automatic reset thermal protection.

SPECIFICATIONS


Power supply required	...................................115V, 60 Hz.
Liquid temp. range		32° to 130°F
Individual branch circuit required (minimum)		......15 Amps
Discharge		1-1⁄2" NPT

UNPACKING AND INSPECTION

Handle with care. Check items received against packing list to be sure that all equipment has been received. Inspect for shipping damage. If found, file claim with carri- er immediately.

GENERAL SAFETY INFORMATION

Electrically powered sump pumps normally give many years of trouble-free service when correctly installed, maintained, and used. However, unusual circumstances (interruption of power to the pump, dirt/debris in the sump, flooding that exceeds the pump’s capacity, electri- cal or mechanical failure in the pump, etc.) may prevent the pump from functioning normally. To prevent possible water damage due to flooding, consult your dealer about installing a high water alarm. See the “Troubleshooting Chart” in this manual for information about common sump pump problems and remedies. For more informa- tion, see your dealer or call customer service.

1.Know the pump application, limitations, and potential hazards.

2.Disconnect power before servicing.

3.Release all pressure within system before servicing any component.

4.Drain all water from system before servicing.

5.Secure discharge line before starting pump. An unse- cured discharge line will whip, possibly causing per- sonal injury and/or property damage.

6.Check hoses for weak or worn condition before each use, making certain that all connections are secure.

7.Periodically inspect system components. Keep free of debris and foreign objects. Perform routine mainte- nance as required.

8.Provide means of pressure relief for pumps whose dis- charge line can be shut-off or obstructed.

9.Personal Safety:

a.Wear safety glasses at all times when working with pumps.

b.Keep work area clean, uncluttered and properly lighted – replace all unused tools and equipment.

c.Keep visitors at a safe distance from work area.

d.Make workshop child-proof – with padlocks, mas- ter switches, and by removing starter keys.

10.When wiring an electrically driven pump, follow all electrical and safety codes that apply.

11.This equipment is only for use on 115 volt (single phase) and is equipped with an approved

3-conductor cord and 3-prong, grounding-type plug.

To reduce risk of electric shock, pull plug before servicing. This pump has not been investigated for use in swimming pool areas. Pump is supplied with a grounding conductor and grounding-type attachment plug. Be sure it is connected only to a properly grounded grounding-type receptacle. Where a 2-prong wall recepta- cle is encountered, it must be replaced with a properly grounded 3-prong receptacle installed in accordance with codes and ordinances that apply.

12.All wiring should be performed by a qualified electrician.

13.Make certain power source conforms to requirements of your equipment.

PERFORMANCE

			GPM of Water @ Total Feet of Head
Model	HP	5’		10’	15’	20’	Shutoff
DP233110V-01	1/3	48.0		40.0	29.0	15.0	24’

SPECIFICATIONS

	Motor
	Full Load	Switch Setting			Top	Bottom
HP	Amps	On	Off	Height	Width	Width	Weight
1/3	9.8	7"	2"	13-3/4"	15-1/8"	12"	32 lbs.