Genie GS-3390, GS-4390, GS-5390, GS-3384 manual Check the Engine Oil Level

Page 16

Operator's Manual	Second Edition • Third Printing

MAINTENANCE

Check the Engine Oil Level

Maintaining the proper engine oil level is essential to good engine performance and service life. Operating the machine with an improper oil level can damage engine components.

Check the oil level with the engine off.

1Release the latches on the engine tray and fully slide the engine tray out.

2Insert a 15 cm screwdriver or rod into the engine tray lock hole, located near the engine tray roller wheels, to prevent the engine tray from moving.

3Check the oil level dipstick. Add oil as needed.

Deutz F4L1011F Engine

Oil Type	15W-40
Oil Type - cold conditions	10W-40

Deutz F3L1011(F) Engine

Oil Type	15W-40
Oil Type - cold conditions	10W-40

Deutz F3L2011 Engine

Oil Type	15W-40
Oil Type - cold conditions	5W-30

Deutz F3L2011 Tier II Engine

Oil Type	15W-40
Oil Type - cold conditions	5W-30

GM 1.6L Engine

Oil Type	10W-30

Ford LRG-425 EFI Engine

Oil Type	10W-40
Oil Type - cold conditions	10W-30

Ford LRG-425 EFI Engine, EPA 2004 Compliant

Oil Type	10W-40
Oil Type - cold conditions	5W-30

14

Genie GS-3384 & GS-3390 & GS-4390 & GS-5390

Part No.82828

Image 16

Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessMachines without capacity indicator Machines with capacity indicatorElectrocution Hazards Tip-over HazardsMaximum capacity GS-4390 Maximum occupants Maximum allowable manual force Fall Hazards Collision Hazards Component Damage Hazards Explosion and Fire HazardsDamaged Machine Hazards Crushing HazardsOutrigger Safety Tip-over Hazards Battery Safety Burn HazardsExplosion Hazard Electrocution HazardPage Controls Ground Control PanelPlatform Controls Pre-operation Inspection FundamentalsPre-operation Inspection Maintenance Maintenance Symbols LegendObserve and Obey Check the BatteriesCheck the Engine Oil Level Scheduled Maintenance Check the Hydraulic Oil Level Check the Engine Coolant LevelAt the Ground Controls Function TestsTest Emergency Stop Test Up/Down Functions and Function Enable At the Platform ControlsTest the Auxiliary Lowering Test the HornTest Drive and Braking Test the SteeringTest Limited Drive Speed Test the Tilt Sensor Operation Test the Up Limit Switch and the Outriggers GS-5390Test Auxiliary Lowering Workplace Inspection Workplace InspectionOperating Instructions Only use the machine as it was intendedEmergency Stop Starting the EngineOperation From Ground Operation From PlatformTo Extend and Retract Platform Auxiliary LoweringOperation From Ground with Controller Outrigger Operation if equippedFall Protection After Each UseFree-wheel Configuration for Winching Transport and Lifting InstructionsSecuring to Truck or Trailer for Transit Lifting Instructions AxisDecals Decal InspectionEngine Side Ground Controls Specifications Floor Loading InformationSpecifications Stowed, maximum Km/h Platform raised, maximum 12.2 m/39 sec GS-5390 Distributed by