Genie GS-3384 At the Platform Controls, Test Up/Down Functions and Function Enable, Test the Horn

Page 19

Second Edition • Third Printing

Operator's Manual

 

 

 

 

Test Up/Down Functions and Function Enable

The audible warnings on this machine come from the same central alarm. The descent alarm sounds at 60 beeps per minute. The alarm that goes off when the machine is not level sounds at 180 beeps per minute.

7 Do not push the lift function enable button. Push and hold the platform up button.

Result: No function should operate.

8Push and hold the lift function enable button. Push and hold the platform up button.

Result: The platform should raise.

9Push and hold the lift function enable button. Push and hold the platform down button.

Result: The platform should lower. The descent alarm should sound while the platform is lowering.

Test the Auxiliary Lowering

10Push and hold the lift function enable button and raise the platform approximately 60 cm.

11Push in the red Emergency Stop button to shut off the engine.

12Pull out the red Emergency Stop button to the on position.

13Push and hold the lift function enable button. Push and hold the platform down button.

Result: The platform should lower.

14 Turn the key switch to platform control and restart the engine.

FUNCTION TESTS

At the Platform Controls

Test Emergency Stop

15Push in the platform red Emergency Stop button to the off position.

Result: No functions should operate.

16 Pull the red Emergency Stop button out to the on position.

Result: The green power light should come on.

Test the Horn

17 Push the horn button.

Result: The horn should sound.

Test Up/Down Functions and Function Enable

18Start the engine.

19Activate the up/down rocker switch in the direction indicated by the blue arrow.

Result: The platform should not raise.

20 Push and hold the lift function enable button.

21 Activate the up/down rocker switch in the direction indicated by the blue arrow.

Result: The platform should raise.

22Push and hold the lift function enable button.

23Activate the up/down rocker switch in the direction indicated by the yellow arrow.

Result: The platform should lower. The descent alarm should sound while the platform is lowering.

Part No.82828

Genie GS-3384 & GS-3390 & GS-4390 & GS-5390

17

Image 19
Contents Operator’s Manual Contact us ContentsDo Not Operate Unless Safety RulesTip-over Hazards Machines without capacity indicatorMachines with capacity indicator Electrocution HazardsMaximum capacity GS-4390 Maximum occupants Maximum allowable manual force Fall Hazards Collision Hazards Crushing Hazards Component Damage HazardsExplosion and Fire Hazards Damaged Machine HazardsElectrocution Hazard Outrigger Safety Tip-over HazardsBattery Safety Burn Hazards Explosion HazardPage Ground Control Panel ControlsPlatform Controls Fundamentals Pre-operation InspectionPre-operation Inspection Check the Batteries MaintenanceMaintenance Symbols Legend Observe and ObeyCheck the Engine Oil Level Check the Hydraulic Oil Level Check the Engine Coolant Level Scheduled MaintenanceAt the Ground Controls Function TestsTest Emergency Stop Test the Horn Test Up/Down Functions and Function EnableAt the Platform Controls Test the Auxiliary LoweringTest Drive and Braking Test the SteeringTest Limited Drive Speed Test the Tilt Sensor Operation Test the Up Limit Switch and the Outriggers GS-5390Test Auxiliary Lowering Workplace Inspection Workplace InspectionOnly use the machine as it was intended Operating InstructionsOperation From Platform Emergency StopStarting the Engine Operation From GroundAuxiliary Lowering To Extend and Retract PlatformAfter Each Use Operation From Ground with ControllerOutrigger Operation if equipped Fall ProtectionTransport and Lifting Instructions Free-wheel Configuration for WinchingSecuring to Truck or Trailer for Transit Axis Lifting InstructionsDecal Inspection DecalsEngine Side Ground Controls Floor Loading Information SpecificationsSpecifications Stowed, maximum Km/h Platform raised, maximum 12.2 m/39 sec GS-5390 Distributed by