Second Edition • Third Printing | Operator's Manual |
|
|
|
|
OPERATING INSTRUCTIONS
To Position Platform | Indicator Light Flashing Red |
1 Push and hold the lift function enable button.
2 Activate the up/down rocker switch in the desired direction.
To Steer
1Press and hold the function enable switch on the controller.
2Turn the steer wheels with the thumb rocker switch located on the top of the control handle.
To Drive
1Press and hold the function enable switch on the controller.
2Increase speed: Slowly move the control handle off center.
Decrease speed: Slowly move the control handle toward center.
Stop: Return the control handle to center or release the function enable switch.
Use the
Machine travel speed is restricted when the platform is raised.
Drive Select Switch
Machine on incline symbol:
Low range operation for inclines
Indicator Light On Red
If the indicator light is on red, push in and pull out the red Emergency Stop button to reset the system.
If the light stays red, tag and remove the machine from service.
If the indicator light is flashing red, the platform is overloaded and no functions will operate. An alarm will sound at the platform controls.
Remove weight from the platform.
Push in and pull out the red Emergency Stop button to reset the system.
If the platform is still overloaded, the light will continue to flash.
To Extend and Retract Platform
1Lift the platform extension lock handle to the horizontal position.
2Push the platform extension lock handle to extend the platform to the desired position.
Do not stand on the platform extension while trying to extend it.
3 Lower the platform extension lock handle.
Auxiliary Lowering
At the Ground Controls
Push and hold the lift function enable button and activate the down function.
In the event of a power failure, use the backup auxiliary lowering function.
At the Platform Controls
Push and hold the lift function enable button and activate the up/down rocker switch in the down direction.
Part No.82828 | Genie | 23 |