Generac 02010-2, 04164-2 owner manual Installation Checklist

Page 38

Section 3 – Post-installation Start-up Adjustments

PRIMEPACT 50 Recreational Vehicle Generator

3.5INSTALLATION CHECKLIST

LOCATION AND SUPPORT

Generator is properly located.

Generator is properly supported.

Generator is properly restrained.

GENERATOR COMPARTMENT

Compartment construction is proper.

Holes/Openings are vapor-sealed.

Compartment size is correct.

Compartment is vapor-sealed.

Sound insulation is correct.

Floor cutouts are properly completed.

COOLING AND VENTILATING AIR

Airflow is adequate.

Air inlet opening is correct.

Compensate for restrictions.

Check that installation has been tested.

GASOLINE FUEL SYSTEM

Fuel tank complies with all applicable codes.

Fuel system is properly installed and checked for leaks.

OPTIONAL LP GAS FUEL SYSTEM

Fuel system is properly installed and checked for leaks.

Pressure at regulator inlet is correct.

Rated flow of primary regulator is correct.

All parts are properly installed.

Fuel system is properly tested/adjusted.

EXHAUST SYSTEM

Exhaust system complies with all applicable codes.

Exhaust system is properly and safely installed.

ELECTRICAL CONNECTIONS

Connections comply with local code requirements and all National Electrical Codes.

Junction box is properly installed.

Wiring meets all standards.

All connections are correct.

Conduit is properly installed and sealed.

Generator is properly bonded to the vehicle.

BATTERY INSTALLATION

Recommended battery is installed.

Recommended cables are installed.

Cables are clean and tight.

Cables are connected properly.

Proper ventilation is provided.

Terminals are coated with anti-corrosion grease, and terminal covers are positioned.

OPTIONAL ACCESSORIES

Check that remote start/stop panels (if used) are installed properly.

Check that hourmeter kit (if used) is installed properly.

Check that any other options and accessories (if used) are installed properly.

POST INSTALLATION TESTS

Check that all tests are completed properly.

DATE OF INSTALLATION ____________________________________________________

NAME OF INSTALLER ______________________________________________________

SIGNATURE OF INSTALLER ________________________________________________

36 Generac® Power Systems, Inc.

Image 38
Contents Power SYSTEMS, INC Authorized Service Dealer Location IntroductionPart II Installation Instructions Table of ContentsGeneral Hazards Electrical Hazards Model 04164-2 Primepact 50LP Generator IdentificationModel 02010-2 Primepact Generator Applicability SafetySpecifications Generator AC Connection SystemEngine OIL Requirements Optional Propane Fuel SystemFuel Consumption GeneratorOptional Remote START/STOP Panel START/STOP SwitchGenerator Control Panel Fuel PrimerAutomatic Choke Gasoline only Before Starting the EngineApplying Loads to Generator Starting the GeneratorStopping the Generator SUMMER/WINTER Heat Riser SystemProtection Systems LOW OIL Pressure SwitchHigh Temperature Switch Do not Overload the GeneratorAdditional Information Checking the Engine OIL Level Changing the Engine OIL AND/OR OIL FilterCleaning the Foam Precleaner Maintaining the Engine AIR CleanerClean AIR Intake Checking the Engine Spark PlugSpark Arrestor Muffler Cleaning the GeneratorBattery Maintenance WeeklyDrive Belt Exercising the GeneratorReturn to Service OUT of Service ProcedureRemoval from Service Part General Hazards Fire Hazards Equipment Description Purpose and Scope ManualStandards Booklets Generator Engine Operating SpeedMajor Features and Dimensions Generator Support Location and SupportGenerator Location Suspended MountingCompartment Construction Generator CompartmentsGenerator Restraint Compartment SizeAcoustics Sound Insulating MaterialsTypical Noise Abatement 2.2.5 Compartment Floor Cutouts Cooling AIR Inlet Openings Cooling and Ventilating AIRGenerator Airflow Compensating for Restrictions Testing the InstallationGasoline Fuel System Generator Fuel Supply Line LP GAS Fuel SystemFuel Tank Flexible Fuel Line Rigid Fuel LinesVapor Withdrawal Primary RegulatorSome Important Considerations Gaseous CarburetionExcess Flow Valve Exhaust SystemFuel Supply Lines Leakage TestsMufflers and Spark Arrestors Exhaust System SafetyElectrical Connections Type of Exhaust SystemGenerator AC Connections WiringIsolating Different Power Sources ConduitPower Supply Cord Ground Fault Circuit InterruptersBattery Cables Optional AccessoriesRecommended Battery Battery Cable ConnectionsBefore Initial START-UP Post Installation TestsTesting Under Load Remote Panel ModelsInstallation Checklist Troubleshooting Guide Problem Cause CorrectionElectrical Data Electrical Data Exploded Views and Parts Lists QTY Description Exploded Views and Parts Lists REGULATOR, GAS Fuel Exploded Views and Parts Lists Lower Bearing Carrier Exploded Views and Parts Lists ¼/ M6-LOCK Washer To Starter SCROLL, Flywheel Exploded Views and Parts Lists Piston Ring SET Exploded Views and Parts Lists MANIFOLD, Intake Exploded Views and Parts Lists CARBURETOR, GN 410 L/P PURCHASER’S/OWNER’S Warranty Responsibilities Your Warranty Rights and ObligationsMANUFACTURER’S Emission Control System Warranty Coverage Emission Control System Warranty Emission Related Parts Include the FollowingWarranty Schedule CONSUMER/PERSONAL Applications This Warranty Shall not Apply to the Following