Generac 02010-0, 04164-0 owner manual Power Supply Cord, Ground Fault Circuit Interrupters

Page 35

Section 2 – Installation

PRIMEPACT 50 Recreational Vehicle Generator

◆ 2.7.6 POWER SUPPLY CORD

◆ 2.7.7 GROUND FAULT CIRCUIT INTERRUPTERS

The power supply cord must comply with all applic- able codes, standards and regulations. It must be large enough to handle the full amperage to which it will be subjected.

The National Electrical Code (NFPA 70, 551-7) requires that you install ground fault circuit inter- rupters (GFCIs) on all external and some internal electrical receptacles. Contact your manufacturer or dealer for recommendations.

Figure 2.18 – Transfer Switch Isolation Method

Figure 2.19 – Installation With Isolation Receptacle

Generac® Power Systems, Inc. 33

Image 35

Contents Power SYSTEMS, INC Introduction Authorized Service Dealer LocationTable of Contents Part II Installation InstructionsGeneral Hazards Electrical Hazards Primepact 50LP Generator IdentificationModel PrimepactGenerator AC Connection System SafetySpecifications Generator ApplicabilityEngine Optional Propane Fuel SystemFuel Consumption Engine OIL RequirementsFuel Primer START/STOP SwitchGenerator Control Panel Optional Remote START/STOP PanelStarting the Generator Automatic Choke Gasoline onlyBefore Starting the Engine Letting the Engine Stabilize Stopping the GeneratorSUMMER/WINTER Heat Riser System Do not Overload the Generator LOW OIL Pressure SwitchHigh Temperature Switch Protection SystemsAdditional Information Changing the Engine OIL AND/OR OIL Filter Checking the Engine OIL LevelChecking the Engine Spark Plug Maintaining the Engine AIR CleanerClean AIR Intake Cleaning the Foam PrecleanerWeekly Cleaning the GeneratorBattery Maintenance Spark Arrestor MufflerExercising the Generator Drive BeltReturn to Service OUT of Service ProcedureRemoval from Service Part General Hazards Electrical Hazards Generator Engine Operating Speed Purpose and Scope ManualStandards Booklets Equipment DescriptionMajor Features and Dimensions Suspended Mounting Location and SupportGenerator Location Generator SupportCompartment Size Generator CompartmentsGenerator Restraint Compartment ConstructionSound Insulating Materials AcousticsTypical Noise Abatement 2.2.5 Compartment Floor Cutouts Cooling AIR Inlet Openings Cooling and Ventilating AIRGenerator Airflow Compensating for Restrictions Testing the InstallationGasoline Fuel System Rigid Fuel Lines LP GAS Fuel SystemFuel Tank Generator Fuel Supply LineGaseous Carburetion Primary RegulatorSome Important Considerations Vapor WithdrawalLeakage Tests Exhaust SystemFuel Supply Lines Excess Flow ValveType of Exhaust System Exhaust System SafetyElectrical Connections Mufflers and Spark ArrestorsConduit WiringIsolating Different Power Sources Generator AC ConnectionsGround Fault Circuit Interrupters Power Supply CordBattery Cable Connections Optional AccessoriesRecommended Battery Battery CablesRemote Panel Cables Remote Panel ModelsInitial Start Post Installation TestsTesting Under Load Before Initial START-UPInstallation Checklist Appendix 1 Notes Problem Cause Correction Troubleshooting GuideAppendix 3 Electrical Data Appendix 3 Electrical Data Appendix 4 Exploded Views and Parts Lists QTY. Description Appendix 4 Exploded Views and Parts Lists REGULATOR, GAS Fuel Appendix 4 Exploded Views and Parts Lists Lower Bearing Carrier Appendix 4 Exploded Views and Parts Lists Item Part no QTY. Description Appendix 4 Exploded Views and Parts Lists Piston Ring SET Appendix 4 Exploded Views and Parts Lists MANIFOLD, Intake Appendix 4 Exploded Views and Parts Lists BOLT, SHOULDER, M6 X 15 LG PURCHASER’S/OWNER’S Warranty Responsibilities Your Warranty Rights and ObligationsMANUFACTURER’S Emission Control System Warranty Coverage Emission Related Parts Include the Following Emission Control System WarrantyGenerac Power SYSTEMS, INC