Briggs & Stratton 206405GS manual Storage

Page 20

Storage

The generator should be started at least once every seven days and allowed to run at least 30 minutes. If this cannot be done and you must store the unit for more than 30 days, use the following guidelines to prepare it for storage.

Generator Storage

•Clean the generator as outlined in Cleaning.

•Check that cooling air slots and openings on generator are open and unobstructed.

Long Term Storage Instructions

Fuel can become stale when stored over 30 days. Stale fuel causes acid and gum deposits to form in the fuel system or on essential carburetor parts. To keep fuel fresh, use Briggs

&Stratton FRESH START™ fuel stabilizer, available as a liquid additive or a drip concentrate cartridge.

There is no need to drain gasoline from the engine if a fuel stabilizer is added according to instructions. Run the engine for 2 minutes to circulate the stabilizer throughout the fuel system. The engine and fuel can then be stored up to

24 months.

If gasoline in the engine has not been treated with a fuel stabilizer, it must be drained into an approved container. Run the engine until it stops from lack of fuel. The use of a fuel stabilizer in the storage container is recommended to maintain freshness.

WARNING

Fuel and its vapors are extremely flammable and explosive.

Fire or explosion can cause severe burns or death.

WHEN STORING FUEL OR EQUIPMENT WITH FUEL IN TANK

•Store away from furnaces, stoves, water heaters, clothes dryers or other appliances that have pilot light or other ignition source because they can ignite fuel vapors.

WHEN DRAINING FUEL

•Turn generator OFF and let it cool at least 2 minutes before removing fuel cap. Loosen cap slowly to relieve pressure in tank.

•Drain fuel tank outdoors.

•Keep fuel away from sparks, open flames, pilot lights, heat, and other ignition sources.

•DO NOT light a cigarette or smoke.

Change Engine Oil

While engine is still warm, drain oil from crankcase. Refill with recommended grade. See Changing Engine Oil.

Oil Cylinder Bore

•Remove spark plug and pour about 1 ounce (30 ml) of clean engine oil into the cylinder.

•Install spark plug and pull starter handle slowly to distribute oil.

WARNING

Unintentional sparking can result in fire or electric shock.

• NEVER crank engine with spark plug removed.

Other Storage Tips:

1.DO NOT store fuel from one season to another unless it has been treated as described in Long Term Storage Instructions.

2.Replace fuel container if it starts to rust. Rust and/or dirt in fuel can cause problems if it’s used with this unit.

3.Cover unit with a suitable protective cover that does not retain moisture.

WARNING

Storage covers can be flammable.

•DO NOT place a storage cover over a hot generator.

•Let equipment cool for a sufficient time before placing the cover on the equipment.

4.Store generator in clean, dry area.

20

BRIGGSandSTRATTON.COM

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Operator’s Manual Where to Find Us GeneratorEngine Date PurchasedTable of Contents Operator Safety Safety RulesSafety alert symbol is used with a signal word Hazard Symbols and MeaningsBroken bones, fractures, bruises, or sprains could result Engine exhaust from this product containsGenerator produces hazardous voltage Unintentional sparking can result in fire or electric shock When Testing for Engine SparkContact with muffler area can result in serious burns Assembly Shipment ContentsInstall Wheel Kit Unpack GeneratorAdd Fuel Attach Negative Battery CableVerify Engine Oil Level Connecting to a Building’s Electrical System System GroundGenerator Location Special RequirementsFeatures and Controls Battery Charger Cord Sets and ReceptaclesNema L14-30 120/240 Volt AC, 30 Amp, Locking ReceptacleOperation Starting the EngineConnecting Electrical Loads Stopping the EngineCold Weather Operation Move fuel valve to Off positionCreating a Temporary Cold Weather Shelter Building a Cold Weather ShelterSelect the items you will power at the same time Power ManagementDon’t Overload Generator CapacityGenerator Maintenance MaintenanceMaintenance Schedule Engine Maintenance Oil Oil RecommendationsChecking Oil Level Adding Engine OilService Air Cleaner To service the air cleaner, follow these stepsService Spark Plug Service Spark ArresterClean Cooling System Carburetor AdjustmentClean and inspect the spark arrester as follows Check Valve ClearanceStorage Troubleshooting Warranties Emissions Control System WarrantyOwner’s Warranty Responsibilities Claims and Coverage Exclusions MaintenanceEmission Information Limited Warranty Reserved Product Specifications Common Service PartsAC Load Current 800Manual del Operario Dónde encontrarnos GeneradorMotor Fecha de compraResolución de problemas Garantías Seguridad de operarioMontaje Controles y característicasSeguridad de operario Descripción del equipoReglas de seguridad Símbolos de peligro y sus significadosCuando Anada Combustible O Vacíe EL Depósito Cuando Ponga EN Funcionamiento EL EquipoCuando Opere EL Equipo Cuando Transporte O Repare EL EquipoCuando Ajuste O Haga Reparaciones a SU Máquina Generador Cuando Pruebe LA Bujía DEL MotorMontaje Desembalaje del generadorInstale el juego de ruedas El generador se entrega conPara instalar Conecte el cable negativo de la bateríaComprobar el nivel de aceite del motor Agregue combustible El combustible debe reunir los siguientes requisitosEvite el daño del generador Gran altitudTierra del sistema Conexión al sistema eléctrico de un edificioUbicación del generador Requisitos EspecialesControles y características Amperios, monofásica de 60 HzJuegos de cordones y enchufes conectores Cargador de bateríaDispositivo de seguridad de 120/240 V, 30 a Tomas eléctricas dobles de 120 V CA y 20 aOperando Encienda el motorConexión de cargas eléctricas Parada del motorOperación durante un clima frío El motor podría petardear, incendiarse o dañarseAdvertencia No sobrecargar el generador CapacidadEjemplo Control de la energíaMantenimiento del generador MantenimientoPlan de mantenimiento Mantenimiento del motor Aceite Recomendaciones sobre el aceiteComprobación del nivel de aceite Adición de aceite del motorServicio del depurador de aire Limpia BQuite filtro de espuma C y papel el filtro D Servicio del bujíaLimpie e inspeccione el apagachispas de la siguiente manera Sistema de refrigeración de aireComprobación de holgura de la válvula Ajuste del carburadorAlmacenamiento Resolución de problemas Garantías Garantía del sistema de control de emisionesResponsabilidades de la garantía del propietario Operaciones de mantenimiento que se enumeran en lasInformación sobre emisiones Garantía Limitada Corriente Carga de C.A Especificaciones del productoServicio común despide

206405GS specifications

The Briggs & Stratton 206405GS is a powerful and reliable small engine designed for a wide range of applications, particularly in lawn care equipment, generators, and various outdoor power tools. Known for its innovative engineering and robust performance, this engine has garnered attention from both commercial and residential users alike.

One of the standout features of the 206405GS is its advanced overhead valve (OHV) design. This configuration enhances fuel efficiency and improves airflow into the combustion chamber, resulting in better overall performance. The engine's ability to deliver higher torque at lower RPMs makes it ideal for tasks requiring consistent power, such as mowing or tilling.

The Briggs & Stratton 206405GS is equipped with a 206cc displacement, offering a potent power output that can handle challenging yard work. With its easy starting mechanism, users can get their equipment up and running with minimal effort. The inclusion of a recoil starter ensures dependability, even in cold weather conditions.

Another notable characteristic of this engine is its durable construction. It features a heavy-duty, cast iron sleeve for added protection and longevity, allowing it to withstand the rigors of outdoor use. Additionally, the engine’s compact size makes it easy to integrate into various machines, facilitating its widespread adoption in the market.

The 206405GS also benefits from Briggs & Stratton’s exclusive technologies such as ReadyStart®. This system eliminates the need for manual priming, allowing for effortless starting every time. The engine’s built-in oil alert system is another important feature that automatically shuts down the engine in the event of low oil levels, protecting the engine from potential damage.

Maintenance is straightforward, with easy access to the air filter and spark plug, aiding in user convenience and minimizing downtime. The engine's fuel system is optimized for minimal maintenance while still delivering adequate power and efficiency.

In summary, the Briggs & Stratton 206405GS is a well-engineered small engine that combines power, efficiency, and durability. With its advanced features and robust performance, it serves as an ideal solution for various outdoor applications, catering to the needs of homeowners and professionals alike. Its reputation for reliability ensures that it continues to be a popular choice in the competitive market of small engines.
Top Page Image Contents