ASSEMBLY
ASSEMBLY
•9/16” wrench
•Pliers
Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.
If you have any problems with the assembly of your generator, please call the generator helpline at
Unpacking the Generator
1.Set the carton on a rigid flat surface.
2.Open carton completely by cutting each corner from top to bottom.
3.Cut ties holding accessory kit and axle to generator and remove everything from carton.
4.Leave generator on carton to install wheel kit.
Install Wheel Kit
NOTE: Wheel kit is not intended for
•13mm wrench
•Socket wrench with a 13mm socket
Figure 1 — Install Wheel Kit
• Safety glasses
Refer to Figure 1 and install the wheel kit as follows:
1.Tip generator so that engine end is up.
2.Slide axle through both mounting brackets.
3.Place a wheel on each side with raised hub inboard.
4.Place a washer on axle and then place an
5.Install
CAUTION
• Always wear eye protection when installing/removing
6.Repeat step 4 and 5 to secure second wheel.
7.Tip generator so that engine side is down.
8.Line up holes in support leg with holes in generator frame.
9.Attach support leg using 2 capscrews (M8 x 16 mm) and 2 hex nuts.Tighten with a 13mm socket wrench and 13mm wrench.
Capscrew |
|
|
Lock Washer |
|
|
Handle |
|
|
|
| Washer |
| Axle |
|
| Capscrew |
|
Support Leg | Wheel | |
| Nut |
|
| 6 |
|