Intel SE7501CW2 manual Installing the Retention Mechanism, Applying Thermal Grease

Page 13

Intel Server Board SE7501CW2 Installation and Integration Guide

Installing the Retention Mechanism

1.Insert the retention brackets.

2.Tighten the four retention screws.

Applying Thermal Grease

Apply thermal grease to the processor as shown.

Attaching the Heat Sink and Retention

Clips

1.Place the heat sink onto the processor as shown. Heat sink styles may differ.

2.Verify that the tab on the inside of the retention clip engages the slot on the heat sink during installation.

3.The center slot in the clip provides room for side-to-side motion while you engage the retention clip slots on each side.

1. Position both clips as shown. Make sure	2. Slide the clip in the direction shown. Note
the tab (2) above engages in the slot on the	the location of the center plastic tab.
heat sink base.

3. Press downward on the end of the	4. Snap the other end in place as shown.
retention clip to engage the side plastic tab.

Note:

Install both retention clips simultaneously for the easiest installation.

13

Image 13

Contents Server Installation and Integration Guide Revision History Table of Contents Administrator computers Client computers Target Audience Document OverviewThank you Minimum Hardware Requirements Troubleshooting GuideHardware Integration Prepare for AssemblySafety Instructions and Information Important Safety InformationElectrostatic Discharge ESD Installing the I/O Shield Chassis Preparation and Server Board InstallationAbout the I/O Shield Attaching the Gasket to the I/O ShieldInstalling the Rubber Bumper Installing Chassis StandoffsInstalling the Server Board Installing Memory Choosing the Processor Socket Installing the Boxed Intel Xeon ProcessorOpening the Socket Lever Attaching the ProcessorApplying Thermal Grease Installing the Retention MechanismAttaching the Heat Sink and Retention Clips Attaching the Fan/Intake Assembly Installing the Processor Wind TunnelAttaching the Heat Sink Fan Attaching the Wind Tunnel Making Required Connections to the Server Board Making Optional Connections to the Server Board Installing the Serial B Cable Cable Routing Intel Server Chassis SC5200 Installing the Access CoverIDE or Scsi Cables Floppy and Front Panel CablesInstalling into a Rack Rack Mode Installing the Chassis Feet Pedestal ModeFinishing Up Installing the Operating System Updating the BiosLANDesk* Client Manager Installing LANDesk Client ManagerLANDesk System Requirements Installing the Intel SMaRT Tool Thank you for purchasing Intel products