Intel SE7501CW2 manual Cable Routing Intel Server Chassis SC5200, Installing the Access Cover

Page 19

Intel Server Board SE7501CW2 Installation and Integration Guide

Cable Routing – Intel Server Chassis SC5200

To ensure proper airflow within the chassis, follow the cable routing guidelines below.

IDE or SCSI Cables

Cables that connect to devices in the lower device bays should be routed around the EPAC system fan carrier as shown.

1.Route cables as shown.

2.Replace the top half of the EPAC.

Floppy and Front Panel Cables

Route the floppy drive and front panel cables as shown.

Installing the Access Cover

1.Place the cover so the tabs go into the slots on the server. The cover should be flush against the chassis.

2.Slide the cover forward until it stops.

3.Tighten the two captive screws into the rear of the chassis.

19

Image 19

Contents Server Installation and Integration Guide Revision History Table of Contents Administrator computers Client computers Target Audience Document OverviewThank you Minimum Hardware Requirements Troubleshooting GuideHardware Integration Prepare for AssemblySafety Instructions and Information Important Safety InformationElectrostatic Discharge ESD Attaching the Gasket to the I/O Shield Chassis Preparation and Server Board InstallationInstalling the I/O Shield About the I/O ShieldInstalling the Rubber Bumper Installing Chassis StandoffsInstalling the Server Board Installing Memory Attaching the Processor Installing the Boxed Intel Xeon ProcessorChoosing the Processor Socket Opening the Socket LeverApplying Thermal Grease Installing the Retention MechanismAttaching the Heat Sink and Retention Clips Attaching the Fan/Intake Assembly Installing the Processor Wind TunnelAttaching the Heat Sink Fan Attaching the Wind Tunnel Making Required Connections to the Server Board Making Optional Connections to the Server Board Installing the Serial B Cable Floppy and Front Panel Cables Installing the Access CoverCable Routing Intel Server Chassis SC5200 IDE or Scsi CablesInstalling into a Rack Rack Mode Installing the Chassis Feet Pedestal ModeFinishing Up Installing the Operating System Updating the BiosLANDesk* Client Manager Installing LANDesk Client ManagerLANDesk System Requirements Installing the Intel SMaRT Tool Thank you for purchasing Intel products