Eiki LC-X6, LC-SX6 owner manual Lamp Replacement, Reset the Lamp time

Turn off the projector and disconnect the AC plug. Allow the projector to cool for at least 45 minutes.

Loosen each screws on the lamp covers with a screwdriver, and remove the lamp covers.

Loosen 2 screws of each lamp with a screwdriver and pull out one lamp and another with grasping the handle.

Maintenance and Cleaning

Lamp Replacement

When the life of the projection lamp of this projector draws to an	Top Control
end, the LAMP1 and 2 REPLACE indicators light orange. If this
indicator lights orange, replace the lamp with a new one promptly.

CAUTION

For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.

Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot.

LAMP 1 REPLACE	LAMP 2 REPLACE
indicator	indicator

These indicators light orange when the life of the projection lamps draws to an end.

Follow these steps to replace the lamp.

1

2

3

4 Replace the lamp with a new one and tighten the 2 screws back into the positions. Make sure that the lamp is set properly. Replace the lamp covers and tighten the screws.

5	Connect the AC power cord to the projector and turn on the
	projector.
6	Reset the Lamp time.
	See “Lamp time” on p59.

CAUTION :

DO NOT OPERATE A PROJECTOR WHILE ANY OF LAMPS IS REMOVED. IT MAY RESULT IN MALFUNCTIONS, FIRE HAZARD, OR OTHER ACCIDENTS.

NOTES ON LAMP REPLACEMENT:

TO MAINTAIN QUALITY OF PICTURE (BETTER BALANCE OF COLOR AND BRIGHTNESS IN THE ENTIRE SCREEN), WE RECOMMEND REPLACING ALL 2 LAMPS AT A TIME.

Lamp covers

Screws

Lamp 1 Lamp 2

Handle

ScrewsHandle

64