Maintenance and Cleaning
Lamp Replace Indicators
Indicators
READY | LAMP | LAMP 1/2 | Projector Condition | ||
REPLACE |
| ||||
Green | Red |
| |||
| Orange |
| |||
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| The lamp cannot light up. (The projector is preparing for |
|
|
|
|
| projection lamp is being cooled down. The projector cannot be turned on until |
|
|
|
|
| cooling is completed. ) |
|
|
|
|
|
|
|
|
| Slow |
| |
|
|
|
|
|
|
|
|
|
|
| The lamp cannot light up. (The lamp has been cooled down enough and the |
|
|
|
|
| projector is in |
|
|
|
|
| OFF button.) |
|
|
| Slow |
|
|
The lamp is not installed in the projector.
Fast
The lamp of which indicator is blinking has been used overtime. Replace the lamp and then reset the Lamp time. The indicator will turn off.
Both
Either lamp cover is not replaced or fit in.
Both of the indicators keeps blinking three times at regular intervals and the projector cannot be turned on.
Slow
Alternate
Maintenance & Cleaning
Slow
One lamp is different from the other in wattage. (For example, installed a lamp on 300W and the other on 100W.) If the POWER button is pressed in this condition, the projector will be turned on with Lamp 1 only and then shut down automatically 1 minute later.
✽When the LAMP 1 REPLACE indicator and the LAMP 2 REPLACE indicator light orange, replace the projection lamps with new ones promptly. And then reset the Lamp time after replacement of the lamps. See page 59, 64 and 65.
69