MicroJack User’s Manual
EYES Pro/MP2016/MP3000/MP5000
The PTZ camera will run AutoPan based on your preset position
settings. For example, if 
is chosen and the Dwell/Speed of preset position 1 and 2 are 3 seconds/30 per second and 6 seconds/90 per second.
Therefore, once you click the 
AutoPan button, the camera first turns at a speed of 30 /sec from its current position to position
1 and stays for 3 seconds, then from position 1 to 2 at a speed of 90 /sec and stays for 6 seconds. The camera continues to go
around in such a fashion (2Æ3, 3Æ4, 4Æ1, 1Æ2, …..)
PTZ cameras of different makes can have different ways to run the AutoPan function and might differ from the above. Refer to the respective user’s manual of the PTZ camera.
2.Exit PTZ Controller
Simply click 
to exit from PTZ controller interface.
MicroJack User’s Manual
EYES Pro/MP2016/MP3000/MP5000
Status Monitoring
Alarm / Relay /Sensor Status
On the right side of the main surveillance window is a panel that shows alarm, relay and sensor status. Installed sensors are shown in bright color while not installed ones remain dark. Once a sensor is activated, the color will turn yellow. For relays, installed ones are shown in bright color and activated ones turn yellow color.
When an alarm is triggered, the 
will turn
red color.
97 | 98 |