Intel CB60-BX, CB60-ZX manual Copyright, Trademarks

Page 2

Copyright

This publication contains information that is protected by copyright. No part of it may be reproduced in any form or by any means or used to make any transformation/adaptation without the prior written permission from the copyright holders.

This publication is provided for informational purposes only. The manufacturer makes no representations or warranties with respect to the contents or use of this manual and specifically disclaims any express or implied warranties of merchantability or fitness for any particular purpose. The user will assume the entire risk of the use or the results of the use of this document. Further,the manufacturer reserves the right to revise this publication and make changes to its contents at any time, without obligation to notify any person or entity of such revisions or changes.

All Rights Reserved. © 1998

Trademarks

Microsoft® MS-DOS®, WindowsTM and Windows® 95 are registered trademarks of Microsoft Corporation. Intel®,Pentium® II and CeleronTM are registered trademarks of Intel Corporation. Award is a registered trademark of Award Software, Inc. Other trademarks and registered trademarks of products appearing in this manual are the properties of their respective holders.

Caution:

Danger of explosion if battery incorrectly replaced.

Replace only with the same or equivalent type recommended by the manufacturer.

Dispose of used batteries according to the battery manufacturer’s instructions.

Image 2
Contents CB60-BX/ZX 37400849Copyright TrademarksFCC and DOC Statement on Class B Table of Contents Appendix a System Error Messages Appendix B TroubleshootingIntroduction Features and SpecificationsFeatures Expansion Slots ConnectorsIntroduction Desktop Management Interface DMIIrDA Interface System Health Monitor FunctionsPCI Bus Master IDE Controller USB PortsIntroduction Intelligence Package Checklist Virus ProtectionHardware Installation System Board LayoutHardware Installation DIP Switch Settings for Processors For Factory Use Only System MemoryJumper Settings for the CPU’s Front Side Bus Jumper JP2 CPU’s Front Side Bus SelectJumper Settings for Clearing Cmos Data Jumper JP3 Clear Cmos DataJumper Settings for Wake-On-Keyboard/ Wake-On-Mouse Jumper JP1 Wake-On-Keyboard/Wake-On-MouseSerial Ports 2 PS/2 Mouse and Keyboard PortsHardware Installation Parallel Ports Floppy Disk ControllerHardware Installation IDE Hard Disk Interface Adding a Second IDE Hard DriveHardware Installation USB Ports IrDA ConnectorHardware Installation CPU Fan Connector Chassis Fan ConnectorHardware Installation AGP Fan Connector SB-LINK ConnectorHardware Installation Wake-On-LAN Connector Hardware Installation Power Connector COM PW-OK 5VSBHardware Installation 14 J14 LEDs and Switches Keylock Power/Standby LED and Keylock Connector KeylockBasic Input/Output System Award Bios Setup UtilityStandard Cmos Setup Time Award Bios Setup UtilityDate Halt On Drive a and Drive BVideo Award Bios Setup Utility Bios Features Setup Virus WarningBoot Up Floppy Seek Quick Power On Self TestBoot Sequence CPU L1 Cache and CPU L2 CacheTypematic Delay Msec Boot Up NumLock StatusTypematic Rate Setting Typematic Rate Chars/SecHDD S.M.A.R.T. Capability Chipset Features SetupOS Select for Dram 64MB System Bios Cacheable Sdram RAS-to-CAS DelayDram Data Integrity Mode CB60-BX only Video Bios CacheableMemory Hole At 15M-16M Bit I/O Recovery Time and 16 Bit I/O Recovery TimeVideo RAM Cacheable PCI 2.1 ComplianceSpread Spectrum System Health Monitor+1.5V, +3.3V, +5V, +12V, -12V Power Management SetupCpuv PM Control by APM Power ManagementAcpi Function Video Off MethodHDD Power Down Standby ModeSuspend Mode Video Off AfterResume On Ring Soft-Off by PWR-BTTNPWR Lost Resume State Resume On LAN Resume On AlarmTimer hhmmss Date of MonthResources Controlled By Award Bios Setup Utility 5 PNP/PCI ConfigurationReset Configuration Data Assign IRQ for USB Load Fail-Safe SettingsAssign IRQ for VGA PCI Slot 1 Use IRQ to PCI Slot 4 Use IRQIntegrated Peripherals Award Bios Setup Utility Load Optimal SettingsIDE HDD Block Mode Init Display First On-Chip Primary PCI IDE and On-Chip Secondary PCI IDEUSB Keyboard Support KBC Input ClockOnboard FDC Controller UART2 Mode SelectIR Transmission Delay Onboard Serial Port 1 and Onboard Serial PortParallel Port Mode, ECP Mode Use DMA and EPP Mode Select Keyboard/Mouse Power OnSupervisor Password Award Bios Setup Utility User Password IDE HDD Auto DetectionAward Bios Setup Utility Save & Exit Setup Exit Without SavingRunning the DMI Utility Supported SoftwaresDesktop Management Interface DMI Supported Softwares Using the DMI Utility Edit DMISave DMI File Supported Softwares Add DMILoad DMI File Hardware Doctor Utility Supported SoftwaresBeep EnableFaults Count 1 or Polling Interval Temperature UnitPatch Utility for Windows Post Beep Appendix a System Error MessageError Messages System Error Message Monitor/Display Appendix B -TroubleshootingTroubleshooting Checklist Floppy Drive TroubleshootingPower Supply Troubleshooting Hard Drive Parallel PortSystem Board Troubleshooting Serial PortKeyboard