Intel CB60-ZX manual Introduction, Expansion Slots, Desktop Management Interface DMI, Connectors

Page 7

Introduction

1

DIMMs	Memory Size
1MBx64/x72	8MB
2MBx64/x72	16MB
4MBx64/x72	32MB
8MBx64/x72	64MB
16MBx64/x72	128MB
32MBx64/x72	256MB*

CB60-BX

*Supported only when CB60-BX uses registered DIMMs.

Expansion Slots

DIMMs	Memory Size
1MBx64	8MB
2MBx64	16MB
4MBx64	32MB
8MBx64	64MB
16MBx64	128MB

CB60-ZX

The system board is equipped with 1 dedicated AGP slot, 3 dedicated PCI slots, 2 dedicated 16-bit ISA slot and 1 shared PCI/ ISA slot. All PCI and ISA slots are bus masters.

Desktop Management Interface (DMI)

The system board comes with a DMI 2.0 built into the BIOS. The DMI utility in the BIOS automatically records various information about your system configuration and stores these information in the DMI pool, which is a part of the system board's Plug and Play BIOS. DMI, along with the appropriately networked software, is designed to make inventory, maintenance and troubleshooting of computer systems easier. Refer to Chapter 4 for instructions on using the DMI utility.

ATX double deck ports

•2 USB ports

•2 DB-9 serial ports

•1 DB-25 parallel port

•1 mini-DIN-6 PS/2 keyboard port

•1 mini-DIN-6 PS/2 mouse port

Connectors

•1 connector for IrDA interface

•2 IDE connectors

•1 floppy connector

•1 20-pin ATX power supply connector

•1 1 3-pin WOL (Wake-On-LAN) connector

•1 SB-LINK connector

•3 fan connectors for CPU, chassis and AGP fans

7

Image 7

Contents 37400849 CB60-BX/ZXTrademarks CopyrightFCC and DOC Statement on Class B Table of Contents Appendix B Troubleshooting Appendix a System Error MessagesFeatures Features and SpecificationsIntroduction Desktop Management Interface DMI ConnectorsIntroduction Expansion SlotsUSB Ports System Health Monitor FunctionsPCI Bus Master IDE Controller IrDA InterfaceIntroduction Intelligence Virus Protection Package ChecklistSystem Board Layout Hardware InstallationHardware Installation System Memory DIP Switch Settings for Processors For Factory Use OnlyJumper JP2 CPU’s Front Side Bus Select Jumper Settings for the CPU’s Front Side BusJumper JP3 Clear Cmos Data Jumper Settings for Clearing Cmos DataJumper JP1 Wake-On-Keyboard/Wake-On-Mouse Jumper Settings for Wake-On-Keyboard/ Wake-On-Mouse2 PS/2 Mouse and Keyboard Ports Serial PortsFloppy Disk Controller Hardware Installation Parallel PortsAdding a Second IDE Hard Drive Hardware Installation IDE Hard Disk InterfaceIrDA Connector Hardware Installation USB PortsChassis Fan Connector Hardware Installation CPU Fan ConnectorSB-LINK Connector Hardware Installation AGP Fan ConnectorHardware Installation Wake-On-LAN Connector COM PW-OK 5VSB Hardware Installation Power ConnectorHardware Installation 14 J14 LEDs and Switches Keylock Keylock Power/Standby LED and Keylock ConnectorStandard Cmos Setup Award Bios Setup UtilityBasic Input/Output System Date Award Bios Setup UtilityTime Video Drive a and Drive BHalt On Virus Warning Award Bios Setup Utility Bios Features SetupCPU L1 Cache and CPU L2 Cache Quick Power On Self TestBoot Sequence Boot Up Floppy SeekTypematic Rate Chars/Sec Boot Up NumLock StatusTypematic Rate Setting Typematic Delay MsecOS Select for Dram 64MB Chipset Features SetupHDD S.M.A.R.T. Capability Video Bios Cacheable Sdram RAS-to-CAS DelayDram Data Integrity Mode CB60-BX only System Bios CacheablePCI 2.1 Compliance Bit I/O Recovery Time and 16 Bit I/O Recovery TimeVideo RAM Cacheable Memory Hole At 15M-16MSystem Health Monitor Spread SpectrumCpuv Power Management Setup+1.5V, +3.3V, +5V, +12V, -12V Video Off Method Power ManagementAcpi Function PM Control by APMVideo Off After Standby ModeSuspend Mode HDD Power DownPWR Lost Resume State Soft-Off by PWR-BTTNResume On Ring Date of Month Resume On AlarmTimer hhmmss Resume On LANReset Configuration Data Award Bios Setup Utility 5 PNP/PCI ConfigurationResources Controlled By PCI Slot 1 Use IRQ to PCI Slot 4 Use IRQ Load Fail-Safe SettingsAssign IRQ for VGA Assign IRQ for USBIDE HDD Block Mode Award Bios Setup Utility Load Optimal SettingsIntegrated Peripherals KBC Input Clock On-Chip Primary PCI IDE and On-Chip Secondary PCI IDEUSB Keyboard Support Init Display FirstOnboard Serial Port 1 and Onboard Serial Port UART2 Mode SelectIR Transmission Delay Onboard FDC ControllerKeyboard/Mouse Power On Parallel Port Mode, ECP Mode Use DMA and EPP Mode SelectSupervisor Password IDE HDD Auto Detection Award Bios Setup Utility User PasswordExit Without Saving Award Bios Setup Utility Save & Exit SetupDesktop Management Interface DMI Supported SoftwaresRunning the DMI Utility Edit DMI Supported Softwares Using the DMI UtilityLoad DMI File Supported Softwares Add DMISave DMI File Supported Softwares Hardware Doctor UtilityFaults Count 1 or EnableBeep Patch Utility for Windows Temperature UnitPolling Interval Error Messages Appendix a System Error MessagePost Beep System Error Message Troubleshooting Checklist Appendix B -TroubleshootingMonitor/Display Power Supply TroubleshootingFloppy Drive Parallel Port Troubleshooting Hard DriveKeyboard Troubleshooting Serial PortSystem Board