Intel CB60-ZX, CB60-BX manual Introduction Intelligence

Page 9

Introduction

1.1.3 Intelligence

Automatic CPU/Chassis Fan Off

The CPU and chassis fans will automatically turn off once the system enters the Suspend mode.

Dual Function Power Button

Depending on the setting in the BIOS setup, this switch will allow the system to enter the Soft-Off or Suspend mode.

External Modem Ring-on

The Modem Ring-on feature allows the system that is in the Suspend mode or Soft Power Off mode to wake-up/power-on to respond to incoming calls.

Note:

This feature supports external modem only.

RTC Timer to Power-on the System

The RTC installed on the system board allows your system to automatically power-on on the set date and time.

Wake-On-LAN Ready

The Wake-On-LAN function allows the network to remotely wake up a Soft Power Down (Soft-Off) PC.Your LAN card must support the remote wakeup function.

Important:

The 5VSB power source of your power supply must support 720mA (minimum).

Wake-On-Keyboard/Wake-On-Mouse

This function allows you to use the keyboard or mouse to power-on the system. Refer to “Jumper Settings for Wake-On-Keyboard/Wake- On-Mouse” in Chapter 2 and “Keyboard/Mouse Power On” in the Integrated Peripherals setup of the Award BIOS in Chapter 3 for more information.

1

9

Image 9
Contents 37400849 CB60-BX/ZXTrademarks CopyrightFCC and DOC Statement on Class B Table of Contents Appendix B Troubleshooting Appendix a System Error MessagesFeatures and Specifications FeaturesIntroduction Introduction ConnectorsExpansion Slots Desktop Management Interface DMIPCI Bus Master IDE Controller System Health Monitor FunctionsIrDA Interface USB PortsIntroduction Intelligence Virus Protection Package ChecklistSystem Board Layout Hardware InstallationHardware Installation System Memory DIP Switch Settings for Processors For Factory Use OnlyJumper JP2 CPU’s Front Side Bus Select Jumper Settings for the CPU’s Front Side BusJumper JP3 Clear Cmos Data Jumper Settings for Clearing Cmos DataJumper JP1 Wake-On-Keyboard/Wake-On-Mouse Jumper Settings for Wake-On-Keyboard/ Wake-On-Mouse2 PS/2 Mouse and Keyboard Ports Serial PortsFloppy Disk Controller Hardware Installation Parallel PortsAdding a Second IDE Hard Drive Hardware Installation IDE Hard Disk InterfaceIrDA Connector Hardware Installation USB PortsChassis Fan Connector Hardware Installation CPU Fan ConnectorSB-LINK Connector Hardware Installation AGP Fan ConnectorHardware Installation Wake-On-LAN Connector COM PW-OK 5VSB Hardware Installation Power ConnectorHardware Installation 14 J14 LEDs and Switches Keylock Keylock Power/Standby LED and Keylock ConnectorAward Bios Setup Utility Standard Cmos SetupBasic Input/Output System Award Bios Setup Utility DateTime Drive a and Drive B VideoHalt On Virus Warning Award Bios Setup Utility Bios Features SetupBoot Sequence Quick Power On Self TestBoot Up Floppy Seek CPU L1 Cache and CPU L2 CacheTypematic Rate Setting Boot Up NumLock StatusTypematic Delay Msec Typematic Rate Chars/SecChipset Features Setup OS Select for Dram 64MBHDD S.M.A.R.T. Capability Dram Data Integrity Mode CB60-BX only Sdram RAS-to-CAS DelaySystem Bios Cacheable Video Bios CacheableVideo RAM Cacheable Bit I/O Recovery Time and 16 Bit I/O Recovery TimeMemory Hole At 15M-16M PCI 2.1 ComplianceSystem Health Monitor Spread SpectrumPower Management Setup Cpuv+1.5V, +3.3V, +5V, +12V, -12V Acpi Function Power ManagementPM Control by APM Video Off MethodSuspend Mode Standby ModeHDD Power Down Video Off AfterSoft-Off by PWR-BTTN PWR Lost Resume StateResume On Ring Timer hhmmss Resume On AlarmResume On LAN Date of MonthAward Bios Setup Utility 5 PNP/PCI Configuration Reset Configuration DataResources Controlled By Assign IRQ for VGA Load Fail-Safe SettingsAssign IRQ for USB PCI Slot 1 Use IRQ to PCI Slot 4 Use IRQAward Bios Setup Utility Load Optimal Settings IDE HDD Block ModeIntegrated Peripherals USB Keyboard Support On-Chip Primary PCI IDE and On-Chip Secondary PCI IDEInit Display First KBC Input ClockIR Transmission Delay UART2 Mode SelectOnboard FDC Controller Onboard Serial Port 1 and Onboard Serial PortKeyboard/Mouse Power On Parallel Port Mode, ECP Mode Use DMA and EPP Mode SelectSupervisor Password IDE HDD Auto Detection Award Bios Setup Utility User PasswordExit Without Saving Award Bios Setup Utility Save & Exit SetupSupported Softwares Desktop Management Interface DMIRunning the DMI Utility Edit DMI Supported Softwares Using the DMI UtilitySupported Softwares Add DMI Load DMI FileSave DMI File Supported Softwares Hardware Doctor UtilityEnable Faults Count 1 orBeep Temperature Unit Patch Utility for WindowsPolling Interval Appendix a System Error Message Error MessagesPost Beep System Error Message Appendix B -Troubleshooting Troubleshooting ChecklistMonitor/Display Troubleshooting Power SupplyFloppy Drive Parallel Port Troubleshooting Hard DriveTroubleshooting Serial Port KeyboardSystem Board