Intel E7520 Installed Hardware, Installing the Heatsinks for CPUs and MCH, Heatsink Information

Dual-Core Intel Xeon processor LV / E7520 Chipset / 6300ESB ICH

Check jumper settings. Verify that the jumpers are set in their default state. Refer to Section 6.4 for detailed descriptions of all jumpers and their default settings indicated in bold.

2.6.3Installed Hardware

Verify installed hardware. Make sure the following hardware is populated on your evaluation board:

•Two Dual-Core Intel Xeon processors LV with heatsinks

•BIOS FWH

•Battery in holder

Note: The CPU sockets have a screw locking mechanism. The socket has an indication to show if the CPU is locked in place.

Caution: The above hardware should have been correctly installed at the factory. If components are not installed correctly, DO NOT power on the board. Correctly re-install the components before proceeding. If you suspect that any of the kit components have been damaged, contact your Intel field sales representative or local distributor for assistance.

2.6.4Installing the Heatsinks for CPU(s) and MCH

Heatsink Installation: In order for the board to operate properly, a heatsink must be installed on the processors and on the E7520 MCH. DO NOT power on board without a CPU thermal solution. Heatsinks may already come pre-installed on both CPU(s) and MCH. Please refer to this section if you need to remove or re-install the heatsinks.

Tools Needed: Flat head screwdriver and Phillips head screwdriver

Consumable Items Needed: Disposable towels and isopropyl alcohol

Note: CPU heatsinks may be silver or copper in color.

Table 3.	Heatsink Information
	Component	Quantity Per	Heatsink	Part Number	Comments
		Board	Manufacturer
	Dual-Core Intel®	2	Cooler Master*	P/N EEP-N41CS-I1-GP	Active heatsink +
	Xeon® processor LV				back plate
	E7520 MCH	1	Cooler Master	ECB-000208-01	Active heatsink

	Dual-Core Intel® Xeon® processor LV with Intel® E7520 Chipset and Intel® 6300ESB ICH
April 2007	User’s Manual
Order Number: 311274-009	15