
Raptor AT – Installation Guide
Step 2 DRAM, CPU, Disk-on-Chip and
Cables Installation
Depending upon how your Raptor AT is configured you may need to install the following:
•DRAM (DIMMs)
•CPU
•
Raptor AT Memory Configuration
The Raptor AT offers 3 DIMM memory sockets (Locations J28, J27 and J26 – Figure
The Raptor AT uses standard DIMMs. To determine the actual capacity of a 1 by 64 DIMM, simply multiply the 1MB by 8.
CPU Installation
The Raptor AT currently supports the following CPUs:
•Full series of Intel Celeron and PIII processors (PGA 370).
1. Improper installation of the CPU may cause permanent damage to both the system board and the CPU.
2.Always handle the CPU by the edges, never touch the pins.
3.Always use a heatsink and a CPU fan.
8