Intel Raptor AT manual Advanced Cmos Setup, Pri Master Pri Slave Sec Master Sec Slave, Quick Boot

Page 27

Chapter 2:BIOS Configuration

Pri Master	Pri Slave
Sec Master	Sec Slave

Select one of these options to configure the hard disk drive. Select Auto from the drive parameters screen to let AMIBIOS automatically configure the drive. Choose the desired option to configure the drive. Auto will automatically detect your hard drive every time the computer boots. If required, a specific Hard Drive type may be selected.

Boot Sector Virus Protection

The options are either Enabled or Disabled.

Advanced CMOS Setup

Advanced CMOS Setup options are displayed by choosing the Advanced CMOS Setup option from the AMIBIOS Setup main menu. All Advanced CMOS Setup options are described in this section.

Quick Boot

Set this option to Enabled to instruct AMIBIOS to boot quickly when the computer is powered on. This option replaces the old Above 1 MB Memory Test Advanced Setup option. The settings are: Enabled and Disabled.

Pri Master ARMD Emulated as

Pri Slave ARMD Emulated as

Sec Master ARMD Emulated as

Sec Slave ARMD Emulated as

If set to Auto, the default emulation depends on ARMD drive. The default emulation type is floppy for LS120, hard drive for MO and hard drive for ZIP drives.

17

Image 27

Contents Raptor AT Page Chapter Pre-ConfigurationAppendix B Flash Bios Programming Appendix C Disk-On-Chip Appendix a Technical SpecificationsAppendix E On-Board Appendix D On-Board IndustrialRaptor AT Installation Guide Introduction System Board Pre-ConfigurationStatic Electricity Warning On-Board I/O CPU SupportSupported Bus Clocks MemoryOn-Board Ethernet Conventions Used in this ManualStatic Warning Pre-ConfigurationRaptor AT Installation Guide Jumper Types Jumper Locations Jumper LocationsFlash Write-protect Enabled Disabled Cmos ResetReset Cmos Normal Clear Cmos Flash Bios Write ProtectClock JP11 Watchdog Timer SelectionTimeout Clock Speed SelectionEthernet Selection Enabled Disabled ATX Power Supply EnhancementsAddress 110h Closed Open 310h CPU Installation Raptor AT Memory ConfigurationFan Heatsink Designing for thermal performanceAirflow management Disk-on-Chip installationInstalling Cables Power and Control Panel Cables Installing Peripheral CablesPre-Configuration Location of Components and Connectors Connector Description Index of ConnectorsUsers Notes Bios Setup Main Menu SetupStarting Bios Setup Using the Keyboard with Bios SetupStandard Setup Date/TimeFloppy Drive A, B Pri Master Pri Slave Sec Master Sec Slave Advanced Cmos SetupBoot Sector Virus Protection Quick BootHard Disk Access Control Try Other Boot DevicesInitial Display Mode Floppy Access ControlFloppy Drive Seek Boot Up Num LockA.R.T. for Hard Disks Floppy Drive SwapPrimary Display Password CheckBoot to OS/2 Wait for F1 If ErrorC000,16K Shadow C400,16K Shadow Advanced Chipset SetupSystem Bios Cacheable Internal CacheUSB KB/Mouse Legacy Support BX/GX Master Latency Timer ClksMulti-Trans Timer Clks PCI 1 to PCI 0 AccessSdram RAS# to CAS# Delay Aperture Access Global EnablePCI 0 Agent to Aperture Access Memory Autosizing Support Dram Integrity ModeSdram Precharge Control Power Down SdramSearch for MDA Resources Bit I/O Recovery Time 16bit I/O Recovery TimePower Management Setup Video Power Down Mode Power Management/APMPower button Function Green PC Monitor Power StateSuspend Timeout Power Saving TypeStandby / Suspend Timer Unit Standby TimeoutPlug and Play Aware OS PCI/Plug and Play SetupPCI Latency Timer PCI Clocks LAN Wake-UpOff-board PCI IDE Card PCI VGA Palette SnoopAllocate IRQ to PCI VGA PCI IDE Bus MasterDMA Channel Off-board PCI IDE Secondary IRQPCI Device Search Order Peripheral SetupReserved Memory Size Reserved Memory AddressOnboard Serial Port1 Serial Port2 ModeInfra-Red Transmission Mode Parallel Port ModeParallel Port IRQ CPU Current TemperatureCPU Overheat Warning Temperature EPP VersionOnboard IDE Change User PasswordAuto Detect Hard Disk CPU Fan Secondary FanChange Supervisor Password Auto Configuration with Fail-Safe Settings Save Settings and ExitExit without Saving Chapter Upgrading Upgrading the System MemoryUpgrading the Microprocessor Users Notes Bios Appendix aSystem Memory Embedded I/O Miscellaneous Industrial DevicesPCB Construction Control Panel ConnectionsCPU Socket Form FactorData Width System Resource Memory MapDMA Channels Address Range Size Description Decimal HexadecimalAddress hex Description MapPCI Configuration Space Map On-board DevicesBus # Device # Function # Description Signal InterruptsPCI Interrupt Routing Map Device Slave Address Connectors Pin-outEthernet Header J31 Pin# Serial Ports DB9M J36 and J37Pin# Pin# Parallel DB25F J13HDD LED Appendix B Flash Bios Programming Beeps Description Appendix C Disk-On-Chip Users Notes Appendix D On-Board Industrial Devices Watchdog TimerHardware Reset Software ResetPost Code Display AddressCheckpoint Description Code Post Checkpoint CodesTable D-5 Bootblock Recovery Codes Table D-6 Uncompressed Initialization Codes Memory refresh line is toggling. Checking 3Ah Performing the DMA controller 2 base register test next Winbios Adaptor ROM had control and has now returned Table D-7 Bus Checkpoint Codes Bits Description Appendix E On-Board Ethernet Users Notes Page MN-RBXAT-03