Sanyo WTC500AL owner manual Standby mode, Display, Power management

Setting

Display

This function decides whether to display On-Screen Displays.

On	Show all the On-Screen displays. Use
	this function when you want to project
	images after the lamp becomes bright
	enough. The factory default setting is
	in this option.
Countdown Off	Show the input image instead of
	the countdown when turning on the
	projector. Use this function when you
	want to project the image as early as
	possible even when the lamp is not
	bright enough.
Off	Hide the On-Screen Displays except;
	●On-Screen Menu
	●“Power off?” (p.25)
	●“No signal” for Power management
	(p.57)
	●“Please wait ...”
	●Arrows for panning mode(p.47)

Standby mode

This function is available when operating the projector via network.

Eco............. Select “Eco” when you do not use the projector

via network. The projector’s network function will stop when turning off the projector.

Network....... Supply the power to the network function

even after turning off the projector. You can turn on/off the projector via network, modify network environment, and receive an e-mail about projector status while the projector is powered off.

Power management

Display

Use the Point 7 8 buttons to switch between the options.

✔Note:

•When selecting “Network”, the cooling fans may be running depending on the temperature inside the projector even if the projector is turned off.

•When “Eco” is selected, several functions will be restricted. (pp. 17, 20- 22, 55, 57)

•When “Eco” is selected, all of the infrared remote receivers are activated regardless of the RC sensor setting. The projector may be effected the noise of the fluorescent light and so on.

•When “Eco” is selected controlling the projector with RS-232C, it is possible to turn on the projector.

For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not used for a certain period.

If the input signal is interrupted and no button is pressed for more than 30 seconds, the timer display with “No signal” appears. It starts the countdown until the lamp is turned off. The countdown time can be set between 1–30 minutes. Use the Point 7 8 buttons to set the countdown timer.

Power management

Time left before the lamp is off.

56