Sanyo WTC500L owner manual Connecting to a Computer Digital and Analog RGB, Dvi

Installation

Connecting to a Computer (Digital and Analog RGB)

Cables used for connection )(*=Cables are not supplied with this projector.)

• VGA Cable (Mini D-sub 15 pin) (One cable is supplied)*

• HDMI-DVI Cable *	• Serial Control Cable *
• BNC Cable *	• USB Cable *

		DVI	Monitor	Monitor	Serial
USB port	Monitor Output	Output	Output	Input	Output

USB cable

BNC cable

HDMI-DVI cable

VGA cable

VGA cable

Serial

Control

Cable

					MONITOR	CONTROL
	G B R H/V V		ANALOG
USB		HDMI
				IN	OUT		PORT

✔Notes:

•USB cable connection is needed when operating the computer with the remote control.

•When the Standby mode is set to “Eco“ in the Setting, MONITOR OUT and AUDIO OUT are disabled. (p.56)

•See page 84 for ordering optional cables.

Unplug the power cords of both the projector and external equipment from the AC outlet before connecting cables.

✔Notes:

•When DVI signal is connected to HDMI terminal with HDMI-DVI cable, connect the sound signal to AUDIO1 and set up Sound of "HDMI setup" to "AUDIO1". (p.58)

•This projector can be connected to the corresponding equipment of DVI however depending on the equipment there are the cases it does not operate normally ; the image does not appear and the sound is not output.

20