Sanyo WTC500L owner manual Projector is detecting abnormal condition, Immediately

Appendix

The projector is detecting abnormal condition..

	Indicators				Projector Condition
POWER	WARNING WARNING		SHUTTER	LAMP 1/2
green / red	TEMP.	FILTER	blue	REP.
	red	orange		yellow
		✽	✽	✽	The temperature inside the projector is elevated close to
green					the abnormally high level.
					The temperature inside the projector is abnormally high.
					The projector cannot be turned on. When the projector
		✽	✽	✽	is cooled down enough and the temperature returns to
					normal, the POWER indicator lights red and the projector
red					can be turned on. (The WARNING TEMP. indicator keeps
					blinking.) Check and replace the filter.
					The projector has been cooled down enough and the
		✽	✽	✽	temperature returns to normal. When turning on the
					projector, the WARNING TEMP. indicator stops blinking.
red
					Check and replace the filter.
					The lamp cannot light up. (The projector is preparing for
	✽	✽	✽		stand-by or the projection lamp is being cooled down. The
red					projector cannot be turned on until cooling is completed.)
					The lamp cannot light up. (The lamp has been cooled
	✽	✽	✽		down enough and the projector is in stand-by mode and
					ready to be turned on with the ON/STAND-BY button.)
red
green	✽	✽	✽		When either of the 2 lamps is out.
					The lamp has been used overtime. Replace the lamp
✽	✽	✽	✽		immediately.

WARNING FILTER

When the filter detects clogging, reaches a time set in the timer setting or runs out of the filter scroll, the WARNING FILTER indicator lights orange. When this indicator lights orange, replace the filter or the filter cartridge with a new one promptly. Reset the Filter counter and Scroll counter after replacing the filter cartridge (p.65).

LAMP 1/2 REPLACE

When the LAMP 1 REPLACE indicator and the LAMP 2 REPLACE indicator light yellow, replace the projection lamps with new ones promptly. See pages 53-54, 66- 68.

78