Sanyo WTC500L owner manual Pointer

Setting

Pointer

You can emphasize a part of the projected image with this function. Use the Point ed buttons to choose either Spotlight or Pointer and press the SELECT button. Then use the Point 7 8 buttons to select a size of the Spotlight (Large, Middle, or Small) or a pattern of the Pointer (Arrow, Finger, or Dot). (See page 32 for operation.)

Remote control

The eight different remote control codes (Code 1–Code 8) are assigned to the projector; the factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8).

The same code should be set on both the projector and the remote control. For example, operating the projector in “Code 7”, the remote control code also must be switched to “Code 7”.

To change the code for the projector

Select a remote control code in this Setting Menu.

To change the code for the remote control

Press and hold the MENU button and a number button (1–8) on the remote control for more than five seconds to switch between the codes. (See page 17 for details.)

RC sensor

Select a location of the infrared remote receiver of the remote control. See “Remote Control Operating Range” on page 16 for details.

All	Activate All of the front, top and back
	receivers.
Front & Top	Activate the front and top receivers.
Top & Back	Activate the top and back receivers.

Front & Back... Activate the front and back receivers.

Front	Activate only the front receiver.
Top	Activate only the top receiver.
Back	Activate only the back receiver.

Pointer

Use the Point ed buttons to choose either Spotlight or Pointer, and then use the Point 7 8 buttons

to switch between the options.

Remote control

✔Notes:

•When using the projector in the horizontal position without hanging from the ceiling, it is recommended to deactivate the top Infrared Remote Receiver to avoid the effects of the fluorescent light.

•When the Standby mode is set to “Eco“ in the Setting(p.56), all of the infrared remote receivers are activated regardless of the RC sensor setting. After turning Off and On the projector, the RC sensor setting will be activated .

55